oky, i have installed a remote starter (add on), this off course includes a bypass module for the transponder and the car starts fines with he remote starter . however when ever i lock the car with he key less entry (the OEM alarm) and start the car remotely, the alarm goes off but the car starts fine..

i looked on three different sites, which says
site 1;
Factory Alarm Disarm Wire (-): Green/Red
Factory Alarm Disarm Wire Location: In Drivers Kick Panel

site 2
FACTORY ALARM DISARM GREEN/RED (-) IN DRIVERS KICK PANEL

so i trying to find the Green/RED wire but i cant find it ?? any idea where its located or in which area i should look??

 

check out my thread...

https://www.rx8club.com/series-i-interior-audio-electronics-24/rx8-wire-colors-locations-177199/

Disarm (key) 18ga. Green/Red (-) @ 0 ohm in driver’s door harness (extended pulse will unlock all doors)

you can test this wire by putting a probe on the wire., then unlocking the driver door with the key until the wire shows a change. i dont remember if it is negative or positive though. make sure you test it afterwards by setting off the alarm. i tapped the wrong wire the first time. it tested, but didnt disarm the factory alarm. anyway....let me know how it goes.

 

hi,

first off, thank you for your reply... but what i did is trace the wire from the door and i finally found it...the good news is that the alarm will disarm but it also unlocks the door.. which is more than what i was wanting to do

right now, i thinking of building a bord that will lock the door right after it unlocks it...unless you know a way of disarming the alarm with out opening the door?