Looking for a DIY Door light install
#1
Looking for a DIY Door light install
i just got some door lights from rotaryfx and i need a DIY
ive searched but nothing came up.
Is there a way to do it without removing the door panel? If so Let me know
If not, and i have to remove the door panel then that answers my questions.
any helps would be great thanks!
ive searched but nothing came up.
Is there a way to do it without removing the door panel? If so Let me know
If not, and i have to remove the door panel then that answers my questions.
any helps would be great thanks!
#2
Registered
iTrader: (15)
Yes you can replace those lights without removing the panel. Just remove the lens using a flathead screw driver, it should pop out easily. When installing the new bulb, beware not to push too hard or you will pop out the socket and it will fall behind the door panel.
This happened to me, and to remedy this I just had to pop out the corner of the door panel to put the socket back in place, you wont need to remove the whole door panel.
This happened to me, and to remedy this I just had to pop out the corner of the door panel to put the socket back in place, you wont need to remove the whole door panel.
Thread
Thread Starter
Forum
Replies
Last Post
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM