Hi Folks,

I've had a problem with my auto headlight levelling system for a while now.
Thought it was about time to sort it out. After testing both sensors, the front one
was found to be well f*cked. So much corrosion and one connecting pin broken off!
Anyway, I've descided to replace it with a variable resistor and mount this on the dash for manual control. I removed all the mechanical parts and ran the cable
back up into the engine bay. At the moment I just connected the Resistor to the end connector....Spot-on everthing is now working fine. Headlights raised up to normal position and warning light on dash now out! :-)

My problem now is how to extend the cable through the firewall to the back of the dash. Anyone have a suggestion the best/easiest route to do this ?

Thanks in advance,
G

 

ya, if you look in your engine bay, and down where the pedals are, there is a huge loom of cables going through this rubber thing poke a hole in that, or push the cable under it. There are some pictures of it floating around here somewhere

 

just check the stickies on running amp power wires or scroll down to the similar threads.

 

Thanks guys, I'll go for the rubber gromet on the drivers side
1st thing tomorrow.

Cheers, G