strakes help
#1
FULLY SEMI AUTOMATIC
Thread Starter
iTrader: (9)
strakes help
yes ive searched and ive been here for a while.
anyway following a diy thread on the correct placement of the strakes i still cant get the top one to sit level. it seems that it sits slightly higher at the rear. ive tried to move and adjust them with no better results.
as i said i searched and found several templates in the diy section but it still doesnt help. any clues guys?
thanks jesse
anyway following a diy thread on the correct placement of the strakes i still cant get the top one to sit level. it seems that it sits slightly higher at the rear. ive tried to move and adjust them with no better results.
as i said i searched and found several templates in the diy section but it still doesnt help. any clues guys?
thanks jesse
#3
FULLY SEMI AUTOMATIC
Thread Starter
iTrader: (9)
i believe they are rotary fx. one screw and one plastic "nipple"
#4
Living In The Past
iTrader: (6)
Hmmm. I have the stainless steel strakes from them, and they mount with 2 screws, plus some sticky pads on the ends that touch the paint. I found plenty of slop to adjust the angle, before tightening down the screws.
Maybe you could enlarge the hole in the grille that the nipple engages?
Maybe you could enlarge the hole in the grille that the nipple engages?
#8
FULLY SEMI AUTOMATIC
Thread Starter
iTrader: (9)
mine are cf to match my hood, b pillers, and fender vents. havent gotten to the cf mirror covers and eyelids yet
#12
FULLY SEMI AUTOMATIC
Thread Starter
iTrader: (9)
they are not wrapped per say, painted maby but the locations are the same for mounting. maby im just dumb. i tried several mounting locations from different templets but no luck on the top one. its angled slightly down in the front
#14
FULLY SEMI AUTOMATIC
Thread Starter
iTrader: (9)
both sides
Thread
Thread Starter
Forum
Replies
Last Post
cschoeps
RX-8's For Sale/Wanted
0
08-06-2015 12:44 PM