Replacing rear bumper?
#3
I did it when I installed my exhaust finishers. It's not bad, just screws and clips. MikeB is right, the tail lights have to come out, but they're easy to remove as well. If you're going to do it, take your time with it, you should be fine.
#5
Registered User
Join Date: Aug 2003
Location: T.O. Canada
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Help.
Could mdw33333 and/or VividRacing.com help me out. You two have had experience removing the rear bumper.
I have removed as much screws and fasteners as I could, but still the rear bumper is not coming out.
I have removed the the side trunk linings, removed the two taillights.
Removed the two hex screws on the top of the bumper under the taillights. I think there was two fasteners there that I also removed.
Removed the three fasteners on the bottom bumper rearwards of the muffler.
Removed two hex screws in the rear wheel wells towards the rear bumper.
So what else is there???
I know I am close, please provide any help if anyone can. Perhaps someone with a shopmanual?
BTW, I am planning to install external rear parking sensors.
Thanks in advance.
Could mdw33333 and/or VividRacing.com help me out. You two have had experience removing the rear bumper.
I have removed as much screws and fasteners as I could, but still the rear bumper is not coming out.
I have removed the the side trunk linings, removed the two taillights.
Removed the two hex screws on the top of the bumper under the taillights. I think there was two fasteners there that I also removed.
Removed the three fasteners on the bottom bumper rearwards of the muffler.
Removed two hex screws in the rear wheel wells towards the rear bumper.
So what else is there???
I know I am close, please provide any help if anyone can. Perhaps someone with a shopmanual?
BTW, I am planning to install external rear parking sensors.
Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
BigMikeATL
RX-8's For Sale/Wanted
12
05-26-2016 12:31 AM