hey guys I finally got done with some body mods and was thinking of adding some splitters for the front end. what do u guys think ?

 

I like splitters that run all the way across the front and not just the corners of the car. I think it would look cool with splitter rods.

 

i agree..see if you can fid some splitters that cover the whole front, but rounded off at the same time.

 

splitters CAN be nice if you get the right ones...

 

just get them!

 

yea, get some splitters would rolled edges.

 

They look good on certain kits. I say leave the MS alone.

 

something like this ?


or leave it like this ?

 

the MS kit does give the look that it has splitters already, but it you want it, you should get a one piece to protect the front as well.

 

ngo where can i find something like that ?
thanks

 

not sure about where is a good place to buy them, but i've seen some good ones on www.buddyclub2.com. i've searched plenty of sites looking for splitters and i think look the best. the difficult thing about buying rolled edge splitters is that you cannot cut them for a perfect fit for the bumper like you can the flat splitters.

 

i think they will look nice with the mazdaspeed kit. but if you get it for the front might as well get the carbon fiber piece that goes under the sideskirt too.... just thinking that it might match better.

 

 

so i may just leave it then and lower the car some more.
thanks everyone

 

haha, so this is an appearance mod your looking for, kel? yes lowering always looks bomb. coilover time??

I plan on lowering more too, but i'm in dire need of splitters to give protection for my front.

 

yeah buddy
who knows I may try both, but yeah coils are a must now. as of today I check and I scraped the bottom of my ms already Im pissed cause Im usely very Careful but **** happens especially in jersey where u dont see a hole till after you loose a wheel.