Bulb loose into the rear tailight
#1
Insane8
Thread Starter
Join Date: Jul 2007
Location: Dallas Texas
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Bulb loose into the rear tailight
I was changing the bulb for my rear turn signals and one of the bulbs were loose and it feel into the rear tailight part.... what do i do lol how do i remove the whole taillight?
#3
Registered
iTrader: (1)
-take off the two nuts holding the taillight to the car (10 mm nuts)
-unplug the connectors from the socket (total of 3)
-unplug the connector to the rear led parking light
-pull taillight assembly straight out. (note: there is a tab holding it to the car near the reverse or turn signal section)
now you can move it around, turn it upside down, and get the bulb out.
-unplug the connectors from the socket (total of 3)
-unplug the connector to the rear led parking light
-pull taillight assembly straight out. (note: there is a tab holding it to the car near the reverse or turn signal section)
now you can move it around, turn it upside down, and get the bulb out.
#4
Official Post Whore
iTrader: (2)
-take off the two nuts holding the taillight to the car (10 mm nuts)
-unplug the connectors from the socket (total of 3)
-unplug the connector to the rear led parking light
-pull taillight assembly straight out. (note: there is a tab holding it to the car near the reverse or turn signal section)
now you can move it around, turn it upside down, and get the bulb out.
-unplug the connectors from the socket (total of 3)
-unplug the connector to the rear led parking light
-pull taillight assembly straight out. (note: there is a tab holding it to the car near the reverse or turn signal section)
now you can move it around, turn it upside down, and get the bulb out.
I did this a few months ago and should not take much time.
Thread
Thread Starter
Forum
Replies
Last Post
nowakm99
Series II Technical and Trouble shooting
1
10-09-2015 07:10 AM