I have a 1888 Rx7 T2. I am in the middle of hooking up the wirring harness.

1. Looking over the directions, I noticed they mention hooking the Knock up to, "Knock 1-2, Water temp signal, Intake Temp signal". I have located the Water and Intake Temp wires on the E-harness, but am confused on the Knock wire. I do not see a extra wire for Knock.

2. Also, where does the atmosphereic pressure wire go to?

3. What about the Idle control valve wirring? Is that needed?

4. is the Analog input/Output wire used?

5. What about the Speed signal wirring? Is that needed?



Thanks all!
Chris