rx-8 turbo boost controller problem
#1
rx-8 turbo boost controller problem
hi,
i have an rx-8 with greddy turbo kit. when i run without boost controller, it run fine but when i plug a MBC( closed) its too rich when Its WOT, it down to 10 A/f...i have the MM Fi base map. what can cause it?
thanks
Matmk318t
i have an rx-8 with greddy turbo kit. when i run without boost controller, it run fine but when i plug a MBC( closed) its too rich when Its WOT, it down to 10 A/f...i have the MM Fi base map. what can cause it?
thanks
Matmk318t
#2
Banned
iTrader: (3)
o rly? And how did you acquire that calibration?
What did you expect it to do? It is a base map - it is just designed to get the base data right. If you run it into boost, it is designed to make the car run so rich it won't accelerate. If it does accelerate, it is designed to blow up your motor.
Enjoy that.
What did you expect it to do? It is a base map - it is just designed to get the base data right. If you run it into boost, it is designed to make the car run so rich it won't accelerate. If it does accelerate, it is designed to blow up your motor.
Enjoy that.
#5
uh oh spaghetti ohs
Thread
Thread Starter
Forum
Replies
Last Post
xAgyex
Series I Trouble Shooting
19
11-13-2023 07:51 AM
Mxttz0r
New Member Forum
34
07-05-2019 03:19 AM
Sifu
RX-8 Parts For Sale/Wanted
3
08-30-2015 10:51 PM
accelerate, basemap, boost, connect, controler, controller, fi, greddy, mazda, mazdamaniac, problem, rich, rx8, troubleshooting, turbo, wont