|
Originally Posted by ste94pz
(Post 4834639)
Hi, I'm searching a complete basemap for a stock NA S1 RX-8, a sort of copy of a stock ecu map on an Adaptronic. I found one on the Adaptronic forum, but a lot of settings are missing. Thank you to all of you for the help.
|
so I’m still trying to confirm what specific connector is required for the internal 8 and 6 pin input/output slots on the Select pcb board?
think it may require the Micro JST XH 2.54mm connector, but Adaptronic never seemed to document it any where that I can find. https://cimg3.ibsrv.net/gimg/www.rx8...0b5b27d3a.jpeg anyone, anyone; Bueller? . |
Just dropped an email to tech@adaptronic.com.au referencing this thread and forwarding your picture. If I get a response via email and they don't respond here, I'll be sure to pass the info along.
Your email has been received and created with the ticket reference ID 92706 - Subject: "Select ECU Connector Type", and will be reviewed by Adaptronic support. All the best, Adaptronic Support Team |
The last time I tried to reach out to them it took forever to get a response. Not that I shouldn’t have just gone ahead and asked them, because nobody else seems to know. Thank you.
|
Originally Posted by TeamRX8
(Post 4957308)
The last time I tried to reach out to them it took forever to get a response. Not that I shouldn’t have just gone ahead and asked them, because nobody else seems to know. Thank you.
It is called 6way r/a header Digi-Key Part Number A19454-ND |
thank you Shell :worship:
|
ok, so it is a 1x6-pin JST XH 2.54mm female cable connector
thanks again. . |
| All times are GMT -5. The time now is 01:07 PM. |
© 2024 MH Sub I, LLC dba Internet Brands