I have regular nose pliers.. What do you mean L shaped?

 

like its bent in the middle. im not sure of the correct name but i used those

 

These: http://www.harborfreight.com/cpi/cta...emnumber=33202

Also very useful when installing an AFE short shifter.

 

Oh ok thanks.

btw, do I use them to release the reflector? I've tried using a screw driver, it loosened the reflector but it's not out yet. It's stuck. lol.. God, I'm a noob.

 

oh.. like deform them with the pliers and then pull the reflectors out. that should be easier

 

Yea.. I need those pliers first.

 

After almost a month, I finally took out that reflector piece.. lol..

 

After buying the clear corners in 2008. I just installed them. I've been lazy.. The DIY was amazing.

 

Beautiful.

 

Great DIY. I started at 1 in the morning and finished in 15 mins. Although I decided to do my foglights replacement bulb after that since i was already in that area.

Thanks!

 

subscribed lol

 

Why is putting in amber bulbs needed? These side markers are running lights and not turn markers so being white is fine?

 

Technically, a car needs to have both an amber side marker AND an amber side reflector at the front (to meet US regulations). The stock side marker is both light and reflector. But most people run the side marker with a white bulb (LED most of the time) and have no problems.

 

Just want to say thank you for the guide. I used it to install my JDM clear corners, and they look a lot better than I thought they would! For some reason beyond me, my car already had clear bulbs in it so I don't have that yellowish tint in them, either. I'm pretty satisfied.

But anyway, yeah, thanks for the guide! It was all very simple, but I wouldn't have felt comfortable doing it without this.

 

Sorry quick question. My corners came with bulbs inside which means i only have to disconnect the old bulbs and connect to the new ones that came with it. Do i need to disconnect my battery to do the swap ?? Quick answers please im doing this right now

 

You do not need to disconnect the battery to switch the light bulbs (see picture in post #9 in this thread).

If what you mean is that your corners included a bulb socket, you can simply remove the new sockets and discard them and then use the existing socket installed on your car. You will still want to switch to the amber bulb.

 

Yea thats what i meant SOCKETS !!! They came with an amber bulb and sockets. So just switch the sockets ?? kk Thanks

 

Yes, Just move the new bulbs to the old sockets and plug the old sockets into the new clear corners.

 

Im having a tough time removing the old socket !! Do i just pull them out ? Are there any tabs ? Help please

 

bump .. left my stuff outside unattended

 

If I remember correctly, you turn the socket counter clockwise about 1/4 turn and it should then come straight out.

 

KK thanks !!Ill try it. But i doubt itll work cause the housing fits liek 100 percent

 

I used the old sockets. I just swapped the bulbs. So i didnt have to remove the old sockets.

 

Great DIY!! props to you man

 

Nice DIY, i just ordered my corners fro ICBMOTORSPORTS http://WWW.ICBMOTORSPORT.COM/marxclcolema.html $64.97 or $72.96 with bulbs so for sure i will refer to this DIY when installing mine.
happy dance!