Superfan

I installed the MP3 player I got from Trussville this morning and snapped some pictures.

Superfan

2

Superfan

3

Superfan

4

Superfan

5

Superfan

6

Superfan

7

Superfan

8

Superfan

and after a 6 month gestation, here's my baby.

jtimbck2

Would you consider posting a pic-by-pic narrative of the installation? That would be extremely helpful to those of us who plan to do the install in the future.

BRx8

you have my exact car - black with appearance package! Superfan, how long did it take you to install the MP3 player? also, was it all just snapping the connectors together? no splicing, soldering, etc.?

brothervoodoo

Superfan,

Thanks for the pics, every bit of assistance is appreciated.

And yes the appearance and rotary accents kick as*, that is how my 8 will come in, except for being gray. Have fun with your ride. I will be doing the MP3 "install tango" when my car arrives.

pmacwill

I installed my mp3 player over the weekend. Just a FYI you DO NOT have to go that nuts on the lower console where the shifter is. All you have to do is unsnap the plastic cover so you can get to the 2 ashtray screws. I would not suggest taking it the whole way off. Once you do that, take out 2 screws, undo the bolt (shiney silver and tucked away to the right of the steering wheel up in the hole. Once you look and locate it, it is somewhat obvious). There are 5 connectors once you pop the unit out. 2 underneath with clips. Stick a small screwdriver underneath the clips to disengage them. Then one on the right side (facing the unit) - a black wire (antenna). Then the one on the top and a large multipin connector on the left. Putting it back it is much easier than taking it out since you don't have to worry about disengaging the locks. Once the unit is out of the console, there are 12 red screws. Take them out, pop the old one out and swap. Easy as pie.

Once again, the only tough parts are disengaging the 5 connectors on removal and possibly locating and removing/replacing the side bolt. I'll try to post a picture or 2 of the exact location of the bolt later.

donald121

Superfan,

Thank you for your pics. Could you post some pics that is after you installed the mp3 player? I just wonder how it will look like. Thank you.

Superfan

The unit came with all the instructions. I'll scan them tonight and post them. The whole thing took under an hour to do. The hardest parts was just like pmacwill said the 5 connectors and the bolt on the under side (BTW it's 10mm).

It looks just like the stock radio. The only thing changed was a little trim piece that says "MP3". It a module that you can't see when it's mounted. I'll Post some pics.


--
I tried to get a picture of the 10mm bolt but I couldn't get the angle. Ohh I can't stress this enough, be carefull when removing the unit as it bends in the middle. Pull too hard and it might crack. Just try to pry it out with a flat head screw driver /w the head wrapped in electrical tape.