odula intake pipe
Yup, and if there is room put 1/16 sheet balsa wood between the layers and then again. Get it at the hobby shop. So you wind up with foil-balsa-foil-balsa-foil. You can put it together with contact cement. Or spay on interior glue.
New Member
Joined: Mar 2003
Posts: 9,944
Likes: 2
From: Melbourne, Australia
Originally Posted by Razz1
ok, reduced by 7 degrees.
How hot was it that day?
How hot was it that day?
https://www.rx8club.com/showthread.p...ht=intake+temp
Me talking something on the other thread:
Originally Posted by taka
Boyboydan has a intake temp of 58 degree Cel on a 26 degree humid day. What is an acceptable level? (setup: unsealed K&N typhoon and 2 ducts (one longer than other to the front air damp area)
Originally Posted by Wildcard
My intake temp with my custom intake mod is only 5deg above ambient. Yesterday driving from Canberra to Sydney, the intake temp was 38deg and the ambient temp was 34deg.
With the stock intake, I was typically seeing intake temps 10deg above ambient on average.
With the stock intake, I was typically seeing intake temps 10deg above ambient on average.
Originally Posted by Wildcard
Another intake reading today. Intake temp 29, ambient temp 26. I have two 3 inch tubes directing air from next to the number plate -> directly into the stock airbox. VFAD completely removed. There is no chance of air being sucked from the engine bay. Best $30 I spent on the car.
I have not got the Odula intake yet (in shipment), so I cannot confirm if VFAD removal is required or not.
Cheers Taka
New Member
Joined: Mar 2003
Posts: 9,944
Likes: 2
From: Melbourne, Australia
My comprehensive review and pics
https://www.rx8club.com/australia-new-zealand-forum-37/taka%92s-review-odula-ram-intake-duct-58857/
https://www.rx8club.com/australia-new-zealand-forum-37/taka%92s-review-odula-ram-intake-duct-58857/
Thread
Thread Starter
Forum
Replies
Last Post
