I just havent seen many pics or info on this so I thought I could throw some up.

just a basic look

the split

after the split 2.5"

rear view

closer. yeah its low

perspective

split

left

right

tip

rear pic distant

 

I like it - looks aggressive!!

 

wow n rider , that exhaust sits low. Does it scrape anywhere? Do you still have the exhaust? Can i hear it? Video clip or something.

 

How much does it weigh?

 

that would scrape over every speed hump known to man

 

too low 4 me but looks nice

 

looks nice... but hella low. good luck with that. you'll have bunch of scrapes before you know it.

but still, looks nice. hahah

 

it's low, but it's right between the wheels. the only way you'll scrape is by taking a huge angle on a huge speed bump or anywhere that will stick something 3 inches high under the car. otherwise parking block or going straight up/down steep driveways looks like it could own it up too.

man, i still want this exhaust. all it needs is better tips.

 

~30 lbs




yeah it does hang pretty low. i wonder if the shop could raise it up a little but oh well. i just wanted to try it out, but it is low. Im not all that hot on the tips either, i might get some new ones put on like the RB ones. i like the double wall look of those better

 

Nice looking, but sits really low. It needs it's own skid plate.

hehehe
Post #666.

 

Are those General UHP's??

 

its just beautiful....nice job.........

 

I have a question for N rider89. Is your car lowered and does that play a role on the 3 or so inches from the lowest point of the Helix exhaust? Would there be any possible issues with it scraping. I am assuming it would take almost 3 inches of suspension travel for it to meet with the ground, unless you have a high bump in the road go under the middle of the car.

 

rider, how much did you pay for it?

 

yes they sure are

 

to tell you the truth im not lowered, but my car sits noticeably lower than a stock one. at one of the meets i was comparing my car (with stock wheels & tires) to the one next to me, and it looked like my car was lowered. i had a lot less wheel gap in the rear. now my car is on 19's.

since my car seems to want to sit low that would really contribute to the exhaust hanging so low. also if you got an exhaust shop they could possibly make it higher also.

 

$650

 

that is a nice looking exhaust. and i agree it is freakin low ><

 

that is also a little low for me... it still looks nice though

 

neil,

check your email..

beers

 

looks aggressive as hell, but must be a bitch on bumps

 

Arrived safely back in San Diego around 9:30 PM. I'll pick up the exhaust from the front desk at 9 am in the morning when they open, snap a few pics, and I'll be off to get it put on. I feel like I've been gone for a year; I won that auction back on May 31st!

I wasn't able to view your pictures earlier due to the workplace's firewall, but now I'm back on my own connection I can see it clearly. I will take similar pictures for comparison, as my rx8 is not lowered at all, stock Dunlop 18 tires/suspension.

 

Get a measurement from the bottom of it to the ground. Please.

 

There is 4 inches of clearance on my particular model.

The glue is not quite 4 inches

Left muffler

Center

Right muffler

Lowest point, back

Under view

Above view

 

Wow, thats ugly