Stock Midpipe to Catback Exhaust Gasket Size
#1
Stock Midpipe to Catback Exhaust Gasket Size
Does anyone have the size for the midpipe to catback exhaust gasket? I have a slight leak and, after stacking up autozone gaskets, I would like a one-piece solution. I'm running a gutted SR high flow cat pipe. I swear someone (mazdatrix, RB, someone...) had thick gaskets for this application, but I can't seem to find them now. Any help would be appreciated!
Thanks,
Chris
Edit: It's the two-bolt flange in the picture below:
This is similar to what I am looking for. The one I saw was thicker and had 'padding' material instead of the multi-layer steel:
http://raceroots.com/index.php/produ...et-2-bolt.html
Thanks,
Chris
Edit: It's the two-bolt flange in the picture below:
This is similar to what I am looking for. The one I saw was thicker and had 'padding' material instead of the multi-layer steel:
http://raceroots.com/index.php/produ...et-2-bolt.html
Last edited by cwatson; 01-20-2013 at 05:13 PM.
#5
Registered
If you're using the factory cat-back, keep in mind that it was designed to be a flexing point so it doesn't seal flat with the midpipe but sits right at the funnel-like section of the cat-back.
An alternative is to cut the factory choke and weld a flange for the catback.
An alternative is to cut the factory choke and weld a flange for the catback.
Thread
Thread Starter
Forum
Replies
Last Post
N0P1st0ns
Series I Aftermarket Performance Modifications
4
07-30-2015 09:45 AM