For Trade: Autobahn Front and Sides for MS Front and Sides
For Trade: Autobahn Front and Sides for MS Front and Sides
I'm looking to trade my Shine Replicas of the Auto_bahn front and sides for the Mazdaspeed Front and Sides in Galaxy Gray. There is a small hole that is not visible on the front bumper of the Autobahn. I will take pictures tomorrow during daylight.
I will only do a Local Swap. I'm located in Garden Grove, Ca.
I will only do a Local Swap. I'm located in Garden Grove, Ca.
I don't have a spare bumper to use if I were to sell it. 
Thanks for the bump, it's hard to find a Galaxy Gray MS Front.
I went to the stealership and they said that the MS kit don't come in Galaxy Gray... I also contacted MazdaTrix and they don't carry that either.

I went to the stealership and they said that the MS kit don't come in Galaxy Gray... I also contacted MazdaTrix and they don't carry that either.
Much better way to gauge than the HDR pics.
I believe Photoshop could do the same with filters that is why I assumed it was PSed.
Did the shop you had install reinforce the bumper and sides?
I believe Photoshop could do the same with filters that is why I assumed it was PSed.

Did the shop you had install reinforce the bumper and sides?
I didn't want to put nails through the side of my body so I only screwed it on the ends into the fender liner. The sides held up by 3M Automotive Tape (The red one).
As for the front, it's not reinforced and the 5mph impact brace/bar was removed. (Japanese RX-8's don't have the impact brace/bar for both front and rear.)
As for the front, it's not reinforced and the 5mph impact brace/bar was removed. (Japanese RX-8's don't have the impact brace/bar for both front and rear.)
What kind of camera do you have? I would like to be able to do that with mine LOL.. i am a newb taking pictures...
Kanedrz, to embed pictures in your messages, just get a photobucket account or something and you will be able to embed the pictures in your posts
Kanedrz, to embed pictures in your messages, just get a photobucket account or something and you will be able to embed the pictures in your posts
:/ not if the sides are held up with 3M tape and the reinforcement bar is gone... you should be able to use the rebar, though, just have to remove everything attached to it.
http://www.trademotion.com/partlocat...subcat2=121485
Then have someone paint match it GG. THEN sell ur front/sides Autoexe.


