FD engine modified to fit RX8
Street port
Rotating assembly clearanced, lighted and balanced
By CLR Motorsports
Stock FD upper intake Manifold (no throttle body)
XS lower intake manifold with 4 injectors
Full function engineering primary and secondary fuel rails with AN fittings
Custom rx8 front cover (for installation in rx8) by CLR Motorsports
Light weight flywheel and clutch
And adaptronic series 1 ECU
(No turbo or manifold)
$8500

 

How exactly is the engine modified from stock REW? Is the only modification the rx8 front cover? Any pictures of front cover modifications? Are you willing to sell just the block?

 

he told me CLR build the entire engine, but I never received a reply from requesting receipts

 

Carlos is a very good friend of
mine, he built this engine, I didn’t know I needed a receipt from him to verify he built it!!!

as far as the modification to the front cover or engine to fit, I was not present when it was done I will say it was running in a rx8 ,

 

sir, nobody here knows you from Adam. In addition to treating people like they’re stupid for asking legitimate questions, you also don’t help yourself any by not revealing everything up front. Like it already having been installed and run in a chassis. Yet we’re expected to drop our pants immediately by blindly sending you $8500 cash on a name drop.

I put forward the suggestion that the only reason this engine hasn’t sold yet is because you’re doing everything in your power to make sure that it doesn’t.
.

 

Is this the motor Carlos was building for the 500 HP turbo 8? It looks just like it but the main pulley has changed. If it is the same motor, it was fully balanced and race clearanced by Carlos. All documented on YouTube: The down side is that it has been sitting for a few years.