When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Category: Accessories Price: $4 Private or Vendor Listing: Private Listing Part Fits (you may select multiples): Series I Location (US State/Canada/Int): FL Item Condition: Used
I have 2 rx8 engines disassembled and mostly cleaned. all damaged/rusted parts discarded.
willing to ship to the lower 48 states as long as you pay. pickup is available in Saint Augustine, FL 32086
there are differences on the listed parts FS depending on model year and auto vs manual trans. It seems that you have a mixture of different transmission type parts at a minimum. So some further definition on them may be necessary.
there are differences on the listed parts FS depending on model year and auto vs manual trans. It seems that you have a mixture of different transmission type parts at a minimum. So some further definition on them may be necessary.
ok, because I was pretty sure that the 4-port automatic only came with a steel driveshaft and the CF one was for the high-power 6-port only.
yes, it's left over from the automatic to 6MT conversion. I used the stock aluminum shaft as it was already hooked up to the rear end and worked great.
I've kept all the parts oiled up and stored the best I can without letting rust get to them... living this close to the beach sucks and doesn't suck at the same time.
Hey there, I was looking through the classifieds for some parts I need and found yours only to read you’re looking for a set of stock wheels. I have a full set of clean stock wheels I would be happy to sell you!
Hey there, I was looking through the classifieds for some parts I need and found yours only to read you’re looking for a set of stock wheels. I have a full set of clean stock wheels I would be happy to sell you!
I have two full sets of S1 wheels one with tires one without as well as one set of S2 wheels with tires, I’ll have to get photos of the S1 wheels for you but I have photos of the S2 wheels. I honestly don’t know the pricing on RX stuff yet since I’m so new to it but I was thinking $300 for the S1 wheels no tires, $450 with tires, and $600 for the S2 wheels but I’m open to offers because again..I don’t know the pricing lol also totally open to trades. Also I’m not too far from you, just up in SC barely over the Savannah GA border.
I have some good F but both cores had low CR rear.
and right now I think my pressure plate collapsed or my TOB got chewed up or crushed. Pulling the engine again later today or tomorrow. Sucks because it was all new parts.
I didn't press in the Pilot bearing, and forgot about it. so it didn't last 150 miles before falling apart. Luckily everything, including the input shaft, is OK and G2G. I'm waiting on parts and detailing the engine bay for now.
12-15-2021, 02:53 PM
