Fresh Shine and Fog Light Rewire
Registered User
Joined: Feb 2003
Posts: 581
Likes: 0
From: Long Island
Re: .
Originally posted by MarthaStewart
Since your rx8 is also grey, as soon as I saw it I wondered to myself, if he's going to put a dinosaur on it.
Well, are you going to pop on a few decals of the dinosaurs?
Since your rx8 is also grey, as soon as I saw it I wondered to myself, if he's going to put a dinosaur on it.
Well, are you going to pop on a few decals of the dinosaurs?
Thread Starter
Riot Controller
Joined: Jan 2004
Posts: 2,142
Likes: 0
From: Orlando, FL
lol
if you had told me this two days ago, I would have told you to check into the mad house. luckily i ran across that thread.
yes, my velicoraptor decals are on the boat from Japan right now.
if you had told me this two days ago, I would have told you to check into the mad house. luckily i ran across that thread.
yes, my velicoraptor decals are on the boat from Japan right now.
Thread Starter
Riot Controller
Joined: Jan 2004
Posts: 2,142
Likes: 0
From: Orlando, FL
there's a thread but I'll sum it up for you...
1. open engine bay fuse box.
2. remove the rear (in reference to the engine bay) fuse block by unclipping the 4 snaps.
3. locate the FOG relay, and the brown wire coming out of the bottom.
4.Locate the ACC relay, it's 2 slots to the rear of the FOG relay. you'll see
5. Cut the brown wire and leave a good amount of slack on the relay end of the wire.
6. Locate the small gauge white and red wire coming from the ACC relay.
7. use a wire tap or splice the brown wire into the red/white wire.
this trigger the fogs to come on with the ignition as long as the switch is on. there's a wire to only have them on with the corner markers, but this way they act as DRL's too.
1. open engine bay fuse box.
2. remove the rear (in reference to the engine bay) fuse block by unclipping the 4 snaps.
3. locate the FOG relay, and the brown wire coming out of the bottom.
4.Locate the ACC relay, it's 2 slots to the rear of the FOG relay. you'll see
5. Cut the brown wire and leave a good amount of slack on the relay end of the wire.
6. Locate the small gauge white and red wire coming from the ACC relay.
7. use a wire tap or splice the brown wire into the red/white wire.
this trigger the fogs to come on with the ignition as long as the switch is on. there's a wire to only have them on with the corner markers, but this way they act as DRL's too.
Thread
Thread Starter
Forum
Replies
Last Post