Notices
RX-8 Discussion General discussion about the RX-8 that doesn't fit in one of the specialty forums.
Sponsored by:
Sponsored by: CARiD

Worst Day

Thread Tools
 
Rate Thread
 
Old May 29, 2009 | 04:17 PM
  #1  
Spiker's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 110
Likes: 0
Worst Day

So the hing in the window visor is broke and the whole time it was spliting up the panel. I just realized that it was broken down because it is hanging down. I could not get it to work so I pull the wire out from the visor. Now the radio/door electronics wont work and the engine light is on...anyone got any ideas?
Reply
Old May 29, 2009 | 04:27 PM
  #2  
Sleepy-z's Avatar
Registered
 
Joined: May 2008
Posts: 285
Likes: 4
From: Virginia
check your fuses perhaps, i dunno.
Reply
Old May 29, 2009 | 04:27 PM
  #3  
Alexb's Avatar
desperately needs a drop
iTrader: (1)
 
Joined: Sep 2008
Posts: 1,127
Likes: 1
From: Dallas, Texas
You just yanked it out...
Reply
Old May 29, 2009 | 04:34 PM
  #4  
boizart1's Avatar
Registered User
 
Joined: Jun 2008
Posts: 176
Likes: 0
From: Pembroke Pines, FL
Originally Posted by Alexb
You just yanked it out...

lol would have liked to see ur face when u asked this question
Reply
Old May 29, 2009 | 04:39 PM
  #5  
Spiker's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 110
Likes: 0
No I split the panel and removed the wires. Where do I find the fuses? Btw next week I have alot of important stuff. You think i can still drive with the engine light on?
Reply
Old May 29, 2009 | 04:44 PM
  #6  
JinDesu's Avatar
went back to srsly broke
iTrader: (2)
 
Joined: Mar 2009
Posts: 2,040
Likes: 1
From: Flushing, NY
Originally Posted by Spiker
No I split the panel and removed the wires. Where do I find the fuses? Btw next week I have alot of important stuff. You think i can still drive with the engine light on?

Face your engine, lower right side of the car. It's got a cover. Search the forum, you'll find a picture.
Reply
Old May 29, 2009 | 04:51 PM
  #7  
Spiker's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 110
Likes: 0
How exactly do i reset the fuses?
Reply
Old May 29, 2009 | 04:54 PM
  #8  
JinDesu's Avatar
went back to srsly broke
iTrader: (2)
 
Joined: Mar 2009
Posts: 2,040
Likes: 1
From: Flushing, NY
Originally Posted by Spiker
How exactly do i reset the fuses?
I'm not sure, but how did you remove the wires? Did you pull them out? Cut them? Disconnect them at a point? If they were disconnected properly, there's no reason for those lights to come on and for your electronics to not work.
Reply
Old May 29, 2009 | 05:00 PM
  #9  
CarAndDriver's Avatar
2005 Black RX-8 GT 6M
 
Joined: Jul 2006
Posts: 6,350
Likes: 0
From: San Jose Area
You should have searched on here before you yanked. I think some other people had similar issues. The visors suck. They redesigned up last year.
Reply
Old May 29, 2009 | 05:28 PM
  #10  
Spiker's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 110
Likes: 0
well there is a thing you push on the wire to disconnect them. I not sure maybe in the process they touched eachother. I just checked the driver fuse box and replace a fuse and it didnt work. I dont know how to pull out the fuse in the engine compartment to check them out. (however they seem to be fine).
Reply
Old May 29, 2009 | 05:58 PM
  #11  
Spiker's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 110
Likes: 0
Called the dealer and they said is going to cost about 300$....and holy crap their design of the visor is so stupid..I can make a better one than that..
Reply
Old May 29, 2009 | 06:34 PM
  #12  
User24's Avatar
Registered
iTrader: (1)
 
Joined: Oct 2005
Posts: 772
Likes: 2
From: California, Chula Vista, Otay Ranch
Just tape those leads to keep them from shorting each other out. And go no visor to save weight. Why pay money for plastic crap that's just gonna break eventually? Might as well have gone elise if you want to keep fixing flimsy plastic parts.
Reply
Old May 29, 2009 | 06:39 PM
  #13  
Ross_Dawg's Avatar
Registered Toker
iTrader: (2)
 
Joined: Dec 2007
Posts: 5,545
Likes: 1
From: Bend, OR
Originally Posted by User24
Might as well have gone elise if you want to keep fixing flimsy plastic parts.
OOh burn
Reply
Old May 29, 2009 | 11:32 PM
  #14  
Spiker's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 110
Likes: 0
The electric system is broken says the dealer on the phone which cost 300
and the panel itself cost 100...
Reply
Old May 30, 2009 | 12:06 AM
  #15  
tderse's Avatar
Registered User
 
Joined: Mar 2009
Posts: 2
Likes: 0
Bulletin No: 09-002/07

I just had my visor fixed under warranty. This is the service bulletin number. Hope this helps. It's a known problem.
Reply
Old May 30, 2009 | 12:28 AM
  #16  
Spiker's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 110
Likes: 0
Yea thx that helps! now anyone knows how to get the other 300$ back? x.x
Reply
Old May 30, 2009 | 12:59 AM
  #17  
Keyten's Avatar
Registered User
 
Joined: Jul 2007
Posts: 62
Likes: 0
From: Texas
I did the absolute exact same thing. My visor broke and was hanging down so I tried to tear it off because it was in the way of my vision.

Turns out that the wires that lead to the light in the visor were not coated at the ends so the wires crossed and I though I burnt out my electrical system. The radio wouldn't start and I do think the automatic locks did either. Anyways, I took it to the dealer and played stupid and said it fell off. Mine was under warranty and hopefully yours is too. It just ended up being a blown fuse and they swapped it out in a few minutes and I was on my way.

If yours isn't under warranty, then there is a good chance they are trying to sucker you out of some money.
Reply
Old May 30, 2009 | 09:18 AM
  #18  
Spiker's Avatar
Thread Starter
Registered User
 
Joined: Jun 2007
Posts: 110
Likes: 0
Originally Posted by Keyten
I did the absolute exact same thing. My visor broke and was hanging down so I tried to tear it off because it was in the way of my vision.

Turns out that the wires that lead to the light in the visor were not coated at the ends so the wires crossed and I though I burnt out my electrical system. The radio wouldn't start and I do think the automatic locks did either. Anyways, I took it to the dealer and played stupid and said it fell off. Mine was under warranty and hopefully yours is too. It just ended up being a blown fuse and they swapped it out in a few minutes and I was on my way.

If yours isn't under warranty, then there is a good chance they are trying to sucker you out of some money.
Do you remember which fuse they broke? like which fuse box is it in? I check the driver side and it is fine. I dont know about the engine side. Also did your engine light come on?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Hiroshima_RX
Series I Trouble Shooting
3
Sep 21, 2015 06:28 PM
mitchrx8
New Member Forum
4
Sep 13, 2015 08:05 AM
Sakebomb Garage
Vendor Classifieds
0
Sep 6, 2015 03:30 PM
Sakebomb Garage
Sakebomb Garage
0
Sep 6, 2015 03:29 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 11:31 PM.