I have a bridged series one 6 port. I swapped to the series 2 trans and have an act hd clutch and prolight flywheel what problems are you guys having with this set up

 

what problem are you having?

 

the clutch isnt engaging enough for me to put it in gear an the fork is rubbing on the pressure plate and it only runs when you let off the clutch pedal all the way

 

it won’t work very long regardless once all that grease smeared on the input shaft gets into the clutch friction surface. It needs to be completely disassembled and cleaned thoroughly to remove all that.

Are you sure it’s the correct clutch & flywheel assembly for an RX8? That’s the only way I see this happening assuming it’s all properly installed with the hydraulics fully bled.
.

 

 

did you ask them about it?

 

no I haven't gotten the chance i wants shopping on mazdatrix today an bout new brake fluid container hard lines stainless steel lines master and slave cylinder and the oem clutch and pressure plate I didnt really need the act clutch and pressure plate anyway I just wanted something that would last forever so itll go on the shelf next to all my other parts that gather dust