RB RevI intake
#1
Flyboy
Thread Starter
Join Date: Mar 2005
Location: inside my cockpit
Posts: 298
Likes: 0
Received 0 Likes
on
0 Posts
RB RevI intake
I just had my RB RevI intake installed and I completed it by following the instructions from RB but the problem now is the engine is kind of chocking at idle and the check engine light turns on.
did i miss something ? anyone had similiar problem before with this intake ?
did i miss something ? anyone had similiar problem before with this intake ?
#3
Flyboy
Thread Starter
Join Date: Mar 2005
Location: inside my cockpit
Posts: 298
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by swoope
did you get the red cap on the manifold on? also check to make sure the maf is seated right and the connectors are tight..
beers
beers
i cud not put the red cap back on when i first pulled the hose off. looks like i might have broken something. is there any other way to seal off the manifold ?
#5
Flyboy
Thread Starter
Join Date: Mar 2005
Location: inside my cockpit
Posts: 298
Likes: 0
Received 0 Likes
on
0 Posts
swoop, i have sealed off the manifold with a rubber and noticed engine chocking has stopped but check engine light still remains on
is there anyway to make the light go away ?
is there anyway to make the light go away ?
#6
Zoom-Freakin'-Zoom
iTrader: (5)
it will take several drive cycles...
but. to help the sensors reset...
take off the neg bat cable.. switch the car key to on. then step on the brake...
reattatch the cable..
start car.. it will take a couple drives for the idle to settle down.. that is normal..
beers
but. to help the sensors reset...
take off the neg bat cable.. switch the car key to on. then step on the brake...
reattatch the cable..
start car.. it will take a couple drives for the idle to settle down.. that is normal..
beers
#7
Flyboy
Thread Starter
Join Date: Mar 2005
Location: inside my cockpit
Posts: 298
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by swoope
it will take several drive cycles...
but. to help the sensors reset...
take off the neg bat cable.. switch the car key to on. then step on the brake...
reattatch the cable..
start car.. it will take a couple drives for the idle to settle down.. that is normal..
beers
but. to help the sensors reset...
take off the neg bat cable.. switch the car key to on. then step on the brake...
reattatch the cable..
start car.. it will take a couple drives for the idle to settle down.. that is normal..
beers
huuurraaayyy i followed your above guidance and engine light finally went away
tks so much ...... i owe you
Thread
Thread Starter
Forum
Replies
Last Post