can you fit a twin turbo from an fd, or a single turbo from a fc, since they are both 13b's???

 

the flames shall soon be upon you

 

Yea. Hell a 20b will fit.

But there's more to it than just slapping it in, the next step is getting it to run right.

 

what about just the twin turbo kit or the turbo kit forom the TT, can they bolt on to our renesis??

 

No, but they duct tape on.

 

i heard you can put two turbos and a supercharger on, and you'll be all set. don't forget the nitrous too. you'll be unstoppable.

 

You can put a 1NZ-FE in it. Its going to rock your world !

 

The exhaust ports are in a different spot, so the exhaust manifold wouldn't line up.

 

The correct answer is that with enough time and money anything is possible, including putting a FD or FC engine in the 8. But neither will just drop in, you would have to do a *lot* of custom fabrication and EMS work.

 

How about a carbureted 12A from a 1985 RX-7 1st generation?

Only thing I can't figure out is where to put the choke ****.

 

If you are asking if you can just use the turbos themselves with a Renesis the answer is yes. However it isn't a direct bolt-on affair. The Renesis has 3 exhaust ports while the 13B only has 2. This means you will have to do some custom fabricating of a new exhaust manifold to make them work. This doesn't really make it worth all the effort. While it may be posible to make it work, there'd be better ways to spend your time and money.