Help!!! Check Engine Light!!
#1
Help!!! Check Engine Light!!
Hello guyz! thnx you too much if any1 wanna help me..this ******* light..damn it..CEL...is always on..no1 know wich is the problem..Mazda say to me i have a probelme to the engine and i must change it..it's impossible.It is a big problem ? i think no..
#3
Registered User
Join Date: Dec 2003
Location: Houston, TX
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
I can only tell you what I learned about my rx-8 today. My check engine light came on and stayed on for days on end. I knew that a gas-cap left off or left loose could account for the light coming on. I tightened the bejeezus out of the gas cap and it did nothing.
Turns out... my 3.8 yr old gas cap had ceased to make a good seal with the opening to the gas tank. It was "seeping" fumes or losing pressure - doing something that the computer picked up on and reported as a CEL.
Spring for a new gas cap and see if that does the trick. It's cheaper than an engine ))
Turns out... my 3.8 yr old gas cap had ceased to make a good seal with the opening to the gas tank. It was "seeping" fumes or losing pressure - doing something that the computer picked up on and reported as a CEL.
Spring for a new gas cap and see if that does the trick. It's cheaper than an engine ))
#4
Metatron
iTrader: (1)
First stop should be a code-reader ($90 approx) that can read the info from the computer - make sure you buy one that can handle the new CanBus protocol.
Then you can stop guessing......
S
Then you can stop guessing......
S
#5
^
If your RX8 is completely stock and has absolutely no mods, check your gas cap, it may not be properly tightened or it doesn't seem to be operating up to what it should be. Chances are, that's the reason of your CEL. I had the same problem with my Mazda3, there was something wrong with the mechanism so they had to replace my gas cap.
If it is moded, find out the code and check it out using a scanalyzer.
You can see what the code means here:
https://www.rx8club.com/series-i-tech-garage-22/rx-8-technical-info-cel-codes-pcm-pin-list-collision-guide-26291/
If your RX8 is completely stock and has absolutely no mods, check your gas cap, it may not be properly tightened or it doesn't seem to be operating up to what it should be. Chances are, that's the reason of your CEL. I had the same problem with my Mazda3, there was something wrong with the mechanism so they had to replace my gas cap.
If it is moded, find out the code and check it out using a scanalyzer.
You can see what the code means here:
https://www.rx8club.com/series-i-tech-garage-22/rx-8-technical-info-cel-codes-pcm-pin-list-collision-guide-26291/
#6
Registered User
Join Date: Jul 2007
Location: Austin,TX
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
I can only tell you what I learned about my rx-8 today. My check engine light came on and stayed on for days on end. I knew that a gas-cap left off or left loose could account for the light coming on. I tightened the bejeezus out of the gas cap and it did nothing.
Turns out... my 3.8 yr old gas cap had ceased to make a good seal with the opening to the gas tank. It was "seeping" fumes or losing pressure - doing something that the computer picked up on and reported as a CEL.
Spring for a new gas cap and see if that does the trick. It's cheaper than an engine ))
Turns out... my 3.8 yr old gas cap had ceased to make a good seal with the opening to the gas tank. It was "seeping" fumes or losing pressure - doing something that the computer picked up on and reported as a CEL.
Spring for a new gas cap and see if that does the trick. It's cheaper than an engine ))
#7
Registered User
iTrader: (1)
Join Date: Aug 2007
Location: Portland, ME
Posts: 562
Likes: 0
Received 0 Likes
on
0 Posts
Isn't there a key on /key off cycle that will allow you to read the code numbers via blinking CEL lights?
my old 97 car you'd key on/off 3 times then the light would blink like moorse code for ya.
my old 97 car you'd key on/off 3 times then the light would blink like moorse code for ya.
#9
Administrator
iTrader: (7)
go to autozone, use their code reader
#10
Registered User
then check it with these codes
https://www.rx8club.com/showthread.php?t=26291
https://www.rx8club.com/showthread.php?t=26291
#12
Stop Looking @ my Rotary!
Join Date: Sep 2006
Location: Tracy, Ca
Posts: 383
Likes: 0
Received 0 Likes
on
0 Posts
I don't believe so....You now days have to use and Scan Tool to pull any "Check Engine" codes. Not like the old days. everything getting more advanced. Computers control most of the cars now!
#15
thnx!!
i thank you guys... i'll try to buy a new gas cap for the gas tank... if this doesn't work, i'll try to get a code reader. my mazda rx-8 doesn't show the error codes. hope i'll solve the problem! thanks again for the answers.
#16
Registered
Join Date: May 2005
Location: Connecticut
Posts: 1,085
Likes: 0
Received 0 Likes
on
0 Posts
There is a TSB for the gas cap though. If it is the cap, they should replace it for you for free. I'm on my 4th one now (they had a bit of a problem getting one that sealed properly!).
#18
I have the original gas cap ('05 model). From the day I bought the car, I've never been able to tighten it (the way other gas caps on other cars tighten). Instead, it tightens a little, and then just clicks, no matter how many times I turn it.
Is this normal? I would think my gas cap is defective and should be replaced with the redesigned one, except for one thing: CEL has never come on. What gives?
Is this normal? I would think my gas cap is defective and should be replaced with the redesigned one, except for one thing: CEL has never come on. What gives?
#20
Registered
Join Date: May 2007
Location: Long Point, Ontario, Canada
Posts: 832
Likes: 0
Received 1 Like
on
1 Post
I have the original gas cap ('05 model). From the day I bought the car, I've never been able to tighten it (the way other gas caps on other cars tighten). Instead, it tightens a little, and then just clicks, no matter how many times I turn it.
Is this normal? I would think my gas cap is defective and should be replaced with the redesigned one, except for one thing: CEL has never come on. What gives?
Is this normal? I would think my gas cap is defective and should be replaced with the redesigned one, except for one thing: CEL has never come on. What gives?
i had to have mine replaced a few days ago since it kept throwing a cel, small leak
#22
Administrator
iTrader: (7)
trick to tightening gas cap. hold straight, tighten slowly. Click 3 times, STOP.
You're all set.
You're all set.
#23
Rotary Wanker
I have the original gas cap ('05 model). From the day I bought the car, I've never been able to tighten it (the way other gas caps on other cars tighten). Instead, it tightens a little, and then just clicks, no matter how many times I turn it.
Is this normal? I would think my gas cap is defective and should be replaced with the redesigned one, except for one thing: CEL has never come on. What gives?
Is this normal? I would think my gas cap is defective and should be replaced with the redesigned one, except for one thing: CEL has never come on. What gives?
#24
Registered
The gas cap problem applies to a specific range of VINs. They're listed in the TSB.
FWIW - When my 8's CEL came on because of the gas cap (P0455), I did not see the light engage in any sexual acts, so I suspect the OP's problem is something else.
Ken