Rx8 engine in seven
Hi all wankel / rotary heads :)
I joined this forum since i took on the adventure to build an seven with a 13B renesis engine in it. I bought an UK car as Donor and have mounted the engine in the seven. For the last hurdle to victory i will try to open a new thread about it. Regards, Walter |
you put a renny in an rx7? why? what gen 7?
|
Ow sorry, i ment lotus super seven.
I simply call them seven's not realising that over here there are even more seven's :) :yelrotflm. My current symptom is that the Rx8 doesn't pull beyond 5500 rpm in third, and hesitates in lower gears to climb beyond. - new D585 coils, wires, plugs; - rebuild engine; - UK 2004 231bhp, 6 port; - OMP verified working (with forscan, you can see the actual position and the switch toggling on start-up; - I only had room to place an K&N cone onto the MAF tube; Suspecting: - I reused an old fuel pump; perhaps to small, but the rev limit looks like a very nice limit... - I coudn't use the DSC/ABS unit. So i need to make the messages myself. Perhaps someone can give me the "valid" "known good" canbus messages for: - Clutch switch, it isn't connected yet, but i didn't get the error yet - Speed limit in the MCU?!? - Is it possible that traction control is activated?and limiting power?? would be nice to get valid canbus messages for: Id: - 4C0 - 212 (dash status?? - 204 All above ID's are from DSC/ABS unit. No DTC's present. p.s. : I cant create a thread in Tech Series 1, wy? |
theres a post count and wait time for new members before you can start threads. do you have a cat in the exhaust?
|
Yes, i have one, its not an original one though.
|
What kind? I hope it's an HJS cat. Most cheap stuff won't last.
|
Mhh at the moment no priority. Emissions are fine.
And its deff not clogged. |
Did you use the legit D585s? Or the Chinabay D585?
To check if its ignition. Either buy a HEI coil ignition tester to verify proper spark, or at very least, put a timing gun lead on both of your leading spark plug wires and make sure you are getting a nice steady flash. |
Bought them on ebay, but they are from a brand i think they are aftermarket ones, but no china i hope.
They where send from the USA if that helps. DTS part number: 08-UF-262 Can someone help me with the CAN messages? Anyone have ing an china ELM which can make a scan? Its easy todo! |
All times are GMT -5. The time now is 07:18 AM. |
© 2024 MH Sub I, LLC dba Internet Brands