Thanks BHR
#1
Registered
Thread Starter
Join Date: Mar 2012
Location: New Hope, MN
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Thanks BHR
Just got and installed my BHR ignition kit today (along with new spark plugs). I held my breath when I fired it up (I always worry that I'm going to forget to hook something up) but it started without a problem and runs much smoother. The only real issues I had:
- Hooking the spark plug wires to the coils was tight even after bending the brackets for the wiring loom, especially on the coils for rotor #2.
- The two middle coils partially cover the bolts to secure the mounting plate (not to mention I had to go to the hardware store to get a deep 10mm socket to tighten it down).
Thanks BHR!
- Hooking the spark plug wires to the coils was tight even after bending the brackets for the wiring loom, especially on the coils for rotor #2.
- The two middle coils partially cover the bolts to secure the mounting plate (not to mention I had to go to the hardware store to get a deep 10mm socket to tighten it down).
Thanks BHR!
Thread
Thread Starter
Forum
Replies
Last Post