13b minimum wire loom to start? Help
#1
13b minimum wire loom to start? Help
Hi I am putting a 13b in to a non rotary car. What wires do I need to make the engine start?? I guess fuel pump. Ecu and coils injectors. Do I need the dash clock to make it run??? Thanks or if anyone has a wire diagram
#4
Registered
iTrader: (1)
You'll need the key cylinder from the same car as the ECU, to pass the immobilizer. Depending on what the car is, you'll need to figure out how to get vehicle speed and other data to the dash. And you won't have a hydraulic power steering pump, so that will need to be figured out.
You'll need the entire engine wiring harness obviously.
You'll need the entire engine wiring harness obviously.
Last edited by Loki; 03-24-2024 at 06:09 PM.
#5
It's going in a Ford escort, that has electric steering don't want the dash clocks but unsif I need them to make it start? All I want is engine wire loom, key immobiliser and fuel pump wire?????
Thread
Thread Starter
Forum
Replies
Last Post
Stavesacre21
Series I Interior, Audio, and Electronics
6
08-06-2007 10:53 AM