Looking for Local Help...
#1
Piston Traitor
Thread Starter
Join Date: Aug 2004
Location: McKinney, Tx
Posts: 341
Likes: 0
Received 0 Likes
on
0 Posts
Looking for Local Help...
It's ok, it's ok... no physical labor required, just advice. Anyway, I have been in the process of "rebuilding" the 8. For those that know me understand that it has been through some rough times.
I have been through 4 clutches. One would think that I would be the expert on clutches by now, but am still looking for a good (decent yet affordable) aftermarket clutch. I have had 3 stock clutches (which were horrible) and an Exedy clutch that I have had for 2 years. It just makes noise and has since it was new.
I have been through 4 clutches. One would think that I would be the expert on clutches by now, but am still looking for a good (decent yet affordable) aftermarket clutch. I have had 3 stock clutches (which were horrible) and an Exedy clutch that I have had for 2 years. It just makes noise and has since it was new.
#3
Club Marbles Member
Join Date: Jul 2005
Location: DFW, TX
Posts: 3,252
Likes: 0
Received 0 Likes
on
0 Posts
I got an ACT Street Clutch and Fidanza flywheel and sometimes if I launch too quick I get a chirp from the clutch. Functions perfectly though....replaced throwout bearing for sure, don't remember if I changed the pilot bearing
#4
Piston Traitor
Thread Starter
Join Date: Aug 2004
Location: McKinney, Tx
Posts: 341
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Digitz0070
Series I Aftermarket Performance Modifications
55
07-25-2017 08:40 PM