WTB used blown engine
WTB used blown engine
why not by the powder coated ones from rotaryresurection?
https://www.rx8club.com/rx-8-parts-sale-wanted-44/fs-powdercoated-rotor-housing-display-sets-162167/
https://www.rx8club.com/rx-8-parts-sale-wanted-44/fs-powdercoated-rotor-housing-display-sets-162167/
Thread Starter
I LuV mY Rotary....
iTrader: (10)
Joined: May 2007
Posts: 3,408
Likes: 0
From: killADelPhia
kevin@rotaryresurrection
iTrader: (3)
Joined: Feb 2005
Posts: 1,415
Likes: 61
From: east of Knoxville, TN
sarcasm, actually.
You can't tell jack about the inside of the block, by having an assembled block.
At most you want half of a block, a cut-in-half eshaft, rotor, housing, iron, and stat gear, with a piece of plexiglass on the front...maybe with a crank on the shaft to rotate the rotor inside the housing.
At least you'd want a rotor and rotor housing, to look at.
With the block assembled, you can't even SEE the rotor at all...and what good would that do?
On a renesis you cannot even see inside the exhaust ports.
You can't tell jack about the inside of the block, by having an assembled block.
At most you want half of a block, a cut-in-half eshaft, rotor, housing, iron, and stat gear, with a piece of plexiglass on the front...maybe with a crank on the shaft to rotate the rotor inside the housing.
At least you'd want a rotor and rotor housing, to look at.
With the block assembled, you can't even SEE the rotor at all...and what good would that do?
On a renesis you cannot even see inside the exhaust ports.
I Didn't do it!
Joined: Nov 2008
Posts: 95
Likes: 0
From: Racine, WI
sarcasm, actually.
You can't tell jack about the inside of the block, by having an assembled block.
At most you want half of a block, a cut-in-half eshaft, rotor, housing, iron, and stat gear, with a piece of plexiglass on the front...maybe with a crank on the shaft to rotate the rotor inside the housing.
At least you'd want a rotor and rotor housing, to look at.
With the block assembled, you can't even SEE the rotor at all...and what good would that do?
On a renesis you cannot even see inside the exhaust ports.
You can't tell jack about the inside of the block, by having an assembled block.
At most you want half of a block, a cut-in-half eshaft, rotor, housing, iron, and stat gear, with a piece of plexiglass on the front...maybe with a crank on the shaft to rotate the rotor inside the housing.
At least you'd want a rotor and rotor housing, to look at.
With the block assembled, you can't even SEE the rotor at all...and what good would that do?
On a renesis you cannot even see inside the exhaust ports.
Thread
Thread Starter
Forum
Replies
Last Post