3 rotor RX8 engine bay progress
#1454
angeljoelv
Thread Starter
We did takebit to the dyno once but had some problems. We had to take the car off and havent been back there yet. We did 498 @ 10psi which is not bad considering i drive the car at 18-20 every day.
#1458
So ur pan doesn't it sit too close to the ground? Mine is like 2-3inches from ground depending on my coilovers hight.
Where did u locate ur factory ECU? Did u put it in a vented enclosure? Or a totally water/air tight one?
I'm thinking bout putting mine in between the hood and the crash bar in a sealed box.
#1459
So ur pan doesn't it sit too close to the ground? Mine is like 2-3inches from ground depending on my coilovers hight.
Where did u locate ur factory ECU? Did u put it in a vented enclosure? Or a totally water/air tight one?
I'm thinking bout putting mine in between the hood and the crash bar in a sealed box.
Where did u locate ur factory ECU? Did u put it in a vented enclosure? Or a totally water/air tight one?
I'm thinking bout putting mine in between the hood and the crash bar in a sealed box.
#1460
#1469
angeljoelv
Thread Starter
#1470
Registered
iTrader: (25)
^^You'd be doing everyone here a favor to stop hotlinking photos and upload them properly. I just saw a half dozen other posts by you with "photo not found" being the central theme. A forum full of dead links is just a wasteland meaningless posts ... with the new uploader software it's super easy now.
#1471
angeljoelv
Thread Starter
I had some problems with photobucket in the past and lost a lot o my pictures, thats the only reason there are like that. My apologies if that caused you or anyone else any trouble. Ill give the uploader a look next time im ready to share some pics.