Engin Light on after replacing ignition coils on 2004 Mazda RX8
So i have been having the low idle and stalling issue. Today i replaced the coils and the car would start until i pressed on the gas then it started right up and the idle was around 1500rpms which was great but the engine light and battery light was on. I finally realized that i forgot to connect the wire that goes to the filter. Once i connected it the car turned on fine and stayed turned on but the idle went below 1000rpms its back to where it was in the beginning. Also the check engine light is still on and i tried resetting the ecu but still the same. Did i do something wrong or is there something i must of forgotten.
P.S. Im only 17 so im pretty much a rookie at this
P.S. Im only 17 so im pretty much a rookie at this
Thread
Thread Starter
Forum
Replies
Last Post
dweezil22
NE For Sale/Wanted
12
Sep 9, 2015 10:50 AM
N0P1st0ns
Series I Aftermarket Performance Modifications
4
Jul 30, 2015 09:45 AM




