Well i just wanted to post some new pics of my recent mods. i just got my exhaust put on and started building my fiberglass enclosuerre for the trunk. the exhaust is a full 3 inch exhaust from EXOTICSPEED. Sounds so badass!!! very deep and pretty loud. has 4 inch titanium mufflers/tips. The sub enclosure is almost finished, all thats left is some bondo and paint. ill start building the amp rack as soon as i get some more cash.

http://i82.photobucket.com/albums/j243/Twztd_Conceptz/rx8exhaust001.jpg
http://i82.photobucket.com/albums/j243/Twztd_Conceptz/rx8exhaust003.jpg
http://i82.photobucket.com/albums/j243/Twztd_Conceptz/rx8exhaust010.jpg
http://i82.photobucket.com/albums/j243/Twztd_Conceptz/rx8exhaust005.jpg
http://i82.photobucket.com/albums/j243/Twztd_Conceptz/rx8exhaust009.jpg
http://i82.photobucket.com/albums/j243/Twztd_Conceptz/rx8fiberglassbox004.jpg
http://i82.photobucket.com/albums/j243/Twztd_Conceptz/rx8fiberglassbox002.jpg

That looks so tight... post up a video of the exhaust if you get a chance please!

nice exhaust, but say goodbye to your exhaust shrouds

The exoticspeed exhaust do sound nice.

nice exhaust, but say goodbye to your exhaust shrouds

I was wondering if they might melt. Sick looking exhaust though!

did you get the exoticspeed headers and th full exhaust system

not anymore. exoticspeed made their tips smaller. the previous version, like mine, was 5" tip. The 4" will be fine. agency power has 4" as well..

I have the agency power exhaust...I melted the sh*t out of the shrouds

ditto, single wall tips get fricken hot...good thing your far enough away from the shroud, you'll probably scorch it badly if you paint it...not saying whats going to happen farther inside where its close......happened to me

^not at the bottom,underneath the tip...that's where mine melted the most...

well exhaust sounds great and its just the full exhaust, no headers yet. and fitment was ok, hangers and such were a bit tight, no movement at all. and the tips barely touch the bottom of the shrouds so there is a bit of melting under the tips. the passenger side actually slightly rests on the shroud

Ikes! Yea, your shrouds will melt for sure then. My friend was running with th RB exhaust at the track. Seems you need to "cool" them off after a good run because his melted waaaay down.

yes please post a video of this exhaust

the canisters looks bad ass

Here is a video on youtube of this exhaust with header and high flow cat.

http://www.youtube.com/watch?v=AcSqvnzyPHo