Quick question, if you are installing the Factory Appearance package front lip, does it require any extra pilot hole to be drilled in the bumper face? That said, if you took off the lip, would there be any unsightly holes left behind?

Thanks in advance for any answers.

Rotor On
-L8

4 or 6 holes are drilled if I remember correctly

that is disconcerning.

anyone out there that knows for sure?

it's six holes, I need to install mine, I wonder if anyone out there has the template for it?

thanks, that does not bode well for me.

it's six holes, I need to install mine, I wonder if anyone out there has the template for it?
You don't need a template. If you look on the inside of the bumper, there are small circles with a + in them. That is where you drill.

You don't need a template. If you look on the inside of the bumper, there are small circles with a + in them. That is where you drill.

yup!

AHHH!!! that makes sense, I didn't look yet. is it the same for the rear and sides?

For the rear aero flares, there are two of the same circles that you drill out and then cut out between the two drilled holes making a "slot." For the sides, there is a paper template which you tape to the car and then drill the 4 holes into the side of the car and then two holes into the wheel well.