Notices
Series I Trouble Shooting This is the place to learn more about or discuss any issues you're having with your RX-8

Violent Clicking at startup - Urgent

Thread Tools
 
Rate Thread
 
Old Jun 3, 2009 | 11:28 PM
  #1  
Shnifty's Avatar
Thread Starter
Is Nifty
 
Joined: Jun 2008
Posts: 184
Likes: 1
From: Apple Valley, MN
Violent Clicking at startup - Solved - Belt not seated correctly.

Hello everyone,

So I just got done swapping out my water pump and while I was putting everything back together. Just as I was done I went to tighten the alternator adjustment and dropped my wrench and cause a nice big couple of sparks between my battery and alternator.

Then, When starting my car I get a violent ticking noise. Is it something that I did wrong with the water pump or is it an electrical issue?

Here is a possibly related thread:

https://www.rx8club.com/showthread.p...light=clicking

Thanks for your help,

-Shnifty

Last edited by Shnifty; Jun 4, 2009 at 12:55 AM.
Reply
Old Jun 3, 2009 | 11:35 PM
  #2  
Jon316G's Avatar
Grasshopper
iTrader: (1)
 
Joined: Dec 2006
Posts: 6,779
Likes: 50
From: Streetsboro, OH
Hard to tell with absolute certainty.
Can you have someone in the car while you observe under the hood and try to narrow it down?
Does the ticking sound generate when the key is turned to 'ON' (not starting the car) or does it only tick while starting the car?

Last edited by Jon316G; Jun 3, 2009 at 11:37 PM.
Reply
Old Jun 3, 2009 | 11:38 PM
  #3  
Shnifty's Avatar
Thread Starter
Is Nifty
 
Joined: Jun 2008
Posts: 184
Likes: 1
From: Apple Valley, MN
It doesnt happen in the on position. It starts as soon as I turn over the engine. Think it'd be ok to let it happen for a little bit? The two times I've tried, i shut my car off right away.
Reply
Old Jun 3, 2009 | 11:38 PM
  #4  
Spinning Sushi's Avatar
I <3 Sushi
iTrader: (21)
 
Joined: Aug 2006
Posts: 3,967
Likes: 4
From: SoCal
You probably tensioned the belts wrong.
Reply
Old Jun 3, 2009 | 11:39 PM
  #5  
Jon316G's Avatar
Grasshopper
iTrader: (1)
 
Joined: Dec 2006
Posts: 6,779
Likes: 50
From: Streetsboro, OH
Could be a bad battery. Check the belts like Renesis SE3P mentioned too.
Reply
Old Jun 3, 2009 | 11:40 PM
  #6  
Shnifty's Avatar
Thread Starter
Is Nifty
 
Joined: Jun 2008
Posts: 184
Likes: 1
From: Apple Valley, MN
:/ how do I check that? Obviously I've never done this before.
Reply
Old Jun 4, 2009 | 12:01 AM
  #7  
Shnifty's Avatar
Thread Starter
Is Nifty
 
Joined: Jun 2008
Posts: 184
Likes: 1
From: Apple Valley, MN
ok, so I found out that it was in fact the belt. shame on me, It must have been seated incorrectly because 1 of the groves go cut off. Do you think I'll be able to drive it to pick up a new one? the rest of the belt should be fine still.
Reply
Old Jun 4, 2009 | 12:01 AM
  #8  
Shnifty's Avatar
Thread Starter
Is Nifty
 
Joined: Jun 2008
Posts: 184
Likes: 1
From: Apple Valley, MN
how do I make sure the belt is correctly tightened?
Reply
Old Jun 4, 2009 | 12:11 AM
  #9  
05rx8mazda's Avatar
B.I.G
iTrader: (4)
 
Joined: Aug 2007
Posts: 1,401
Likes: 1
From: AT---EIL
Rule of thumb twist the belt enough to where it has some play id say quarter of a twist.. my rule of thumb unless you wanna get all technical with TQ specs etc etc
Reply
Old Jun 4, 2009 | 12:14 AM
  #10  
Shnifty's Avatar
Thread Starter
Is Nifty
 
Joined: Jun 2008
Posts: 184
Likes: 1
From: Apple Valley, MN
pics
Attached Thumbnails Violent Clicking at startup - Urgent-small1.jpg   Violent Clicking at startup - Urgent-small2.jpg  
Reply
Old Jun 4, 2009 | 12:53 AM
  #11  
Shnifty's Avatar
Thread Starter
Is Nifty
 
Joined: Jun 2008
Posts: 184
Likes: 1
From: Apple Valley, MN
Ok, well thanks for the help. I took it for a test drive and it seems to be fine. I'm hoping that gimp belt holds out until I can get a new one.
Reply
Old Jun 4, 2009 | 01:02 AM
  #12  
chickenwafer's Avatar
Nope
iTrader: (9)
 
Joined: Jan 2007
Posts: 3,312
Likes: 0
From: Denver
You put too much tension on the belt.

Next time test tension by sqeezing two sides of the belt together with your thumb and finger, it should move about 3/4" or so. If it's stiff then it's too tight
Reply
Old Jun 4, 2009 | 01:19 AM
  #13  
TeamRX8's Avatar
Registered
iTrader: (25)
 
Joined: Apr 2005
Posts: 26,936
Likes: 2,141
Originally Posted by Shnifty
ok, so I found out that it was in fact the belt. shame on me, It must have been seated incorrectly because 1 of the groves go cut off. Do you think I'll be able to drive it to pick up a new one? the rest of the belt should be fine still.
I had the exact same thing happen; same noise and same cause, it will be fine until you get a new one
Reply
Old Jun 4, 2009 | 08:53 AM
  #14  
Shnifty's Avatar
Thread Starter
Is Nifty
 
Joined: Jun 2008
Posts: 184
Likes: 1
From: Apple Valley, MN
Ok, thanks.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Danield97
Series I Trouble Shooting
10
Oct 10, 2015 05:58 PM
sccarally
Gulf RX-8 Forum
1
Sep 27, 2015 03:47 PM
Hiroshima_RX
Series I Trouble Shooting
3
Sep 21, 2015 06:28 PM
gt4uk
Series I Trouble Shooting
0
Sep 20, 2015 07:19 PM
gt4uk
New Member Forum
0
Sep 20, 2015 11:41 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 05:14 PM.