Does anybody else have an issue with their front tanabe springs not sitting that low? my rear looks so nice but the front is not that diferent than stock. I preloaded and did all the steps to a proper install. any suggestions.

 

what are you doing later today??

I'll probably be free if you want to stop by - i see dozer lurking in this thread too...

 

yeah well be wrenchin over at my house

 

suggestion: are the springs sitting correctly on the shocks? there's a certain groove that it's supposed to sit in.

how much threading are you seeing on the top bolt of the strut from the engine bay?

 

I blame rob, he fucked up your springs.

 

haha oh jedi.... the groove is correct and its on both sides not just one or the other... uhm i get out at 4:30 and going out around 6:30 between then? but i wont have time to rip everything apart today..

 

no problem - I can take out the struts in about half an hour each side - tops

I've done it like a bunch of times - it's not that hard. Do you have any tools? If you can come down today, we can work on it...

 

ya i have tools

 

wow it's JEDI havn't seen u around 4 awhile....but then i havent' been around for awhile so what do i know?

 

^jedis EVERYWHERE

robb, get in touch with atilla, im outtie

 

yeah man, I dropped you a few lines on your visitor page. Figured you were off studying that Service Manual and you forgot all aobut us.

 

^haha no busy with school and stuff now i'm fittin to be moving to NC in 2 weeks so its been pretty hectic around here lately haha