Notices

tail light filling with water and condensation - HELP!

Thread Tools
 
Rate Thread
 
Old Feb 26, 2008 | 03:05 PM
  #1  
allosaur's Avatar
Thread Starter
Registered User
 
Joined: Feb 2008
Posts: 1
Likes: 0
tail light filling with water and condensation - HELP!

My right tail light has lots of condensation in it. Also, I just took it to the car wash and it seems to have filled up a bit with water. I've noticed this problem in some other RX-8s I've seen on the road. Is this a manufacturer defect? Suggestions? I'm pretty much a noob when it comes to cars. Thanks.
Reply
Old Feb 26, 2008 | 03:20 PM
  #2  
987HYS's Avatar
Dragon Certified
iTrader: (1)
 
Joined: Dec 2005
Posts: 829
Likes: 0
From: Roanoke Tx
If your car is still under warranty, the dealership will fix it. its a common problem, and its a bad gasket in the housing that needs replacing. search for more info
Reply
Old Feb 26, 2008 | 03:21 PM
  #3  
laythor's Avatar
I zoom therefore I am.
 
Joined: Mar 2007
Posts: 4,919
Likes: 12
From: San Jose, CA
it's a common problem on older 8's

search and you'll find the TSB about it

dealer should replace them for you
Reply
Old Feb 26, 2008 | 03:21 PM
  #4  
XLR83N's Avatar
Registered User
 
Joined: Feb 2007
Posts: 281
Likes: 0
From: Sydney Australia
take it to mazda under warranty, if not, umm take the light out and try to find the leak and seal it some how or just buy a new tail light
Reply
Old Apr 30, 2008 | 07:01 AM
  #5  
Minotavr's Avatar
Less Fast, More Furious
 
Joined: Apr 2008
Posts: 102
Likes: 0
From: Bucharest, Romania
Gasket

Replace the gasket ! It's by far the worst thing in an RX-8 !
Reply
Old Apr 30, 2008 | 07:11 AM
  #6  
expo1's Avatar
He's as bad as Can
 
Joined: Feb 2004
Posts: 4,309
Likes: 3
From: Manchester, NJ
If you warranty is still valid go there while the condensation is still there. If the dealer doesn't see it they might not order you a new one.
Reply
Old Apr 30, 2008 | 07:28 AM
  #7  
crimson-rain's Avatar
Registered
 
Joined: Nov 2004
Posts: 621
Likes: 0
minotavr, is it possible to order a new gasket for the tailight? I'm on my 2nd tail light and I'm out of warranty period.
Reply
Old Apr 30, 2008 | 09:01 AM
  #8  
Minotavr's Avatar
Less Fast, More Furious
 
Joined: Apr 2008
Posts: 102
Likes: 0
From: Bucharest, Romania
Originally Posted by crimson-rain
minotavr, is it possible to order a new gasket for the tailight? I'm on my 2nd tail light and I'm out of warranty period.
Of course it is, unfortunately I can't give you the code# for the gasket. But any dealer should know that.
Reply
Old Apr 30, 2008 | 09:54 AM
  #9  
midlifer's Avatar
Registered
 
Joined: May 2005
Posts: 734
Likes: 0
From: Worc. Mass.
If your 8 is not under warranty then you can buy the gasket and do it yourself.

http://www.finishlineperformance.com...cat=302&page=1

Bob
Reply
Old Apr 30, 2008 | 10:17 AM
  #10  
m3pkrobert's Avatar
Registered
iTrader: (1)
 
Joined: Aug 2007
Posts: 284
Likes: 0
From: woodbridge va
drill a small hole in the bottom and it will b fix
Reply
Old Apr 30, 2008 | 07:11 PM
  #11  
crimson-rain's Avatar
Registered
 
Joined: Nov 2004
Posts: 621
Likes: 0
If your 8 is not under warranty then you can buy the gasket and do it yourself.

http://www.finishlineperformance.com...cat=302&page=1

Bob
sweet. and I live relatively close by (I get my 8 serviced there and everyone there in the service department is AWESOME).
Reply
Old Apr 30, 2008 | 07:27 PM
  #12  
rled's Avatar
5Picker
 
Joined: Nov 2004
Posts: 158
Likes: 0
From: Tennessee
My tail light did the same thing. I bought the Mazda gasket, which is stupid expensive, It is just a bit thicker than the original which is just a piece of foam of some sort .Most likely the water is running in at the top of the tail light right below where the water drains off the trunk lid. There is good info on how to remove the tail light right here on the forum. Take it out , dry the water out . I used compressed air, but there are other ways. Get you some clear silicone sealer and put a small bead of the silicone on the rear panel where the gasket contacts the panel.Put your tail light back in and no more water. Hope this helps .
Reply
Old Apr 30, 2008 | 07:54 PM
  #13  
05rex8's Avatar
sold the 8... :(
iTrader: (7)
 
Joined: Feb 2008
Posts: 4,917
Likes: 0
Originally Posted by m3pkrobert
drill a small hole in the bottom and it will b fix
+1 did this and no issues
Reply
Old Apr 30, 2008 | 08:06 PM
  #14  
nuke0907's Avatar
Never Blend In
iTrader: (2)
 
Joined: Oct 2006
Posts: 4,524
Likes: 5
From: Summerville, SC
Originally Posted by m3pkrobert
drill a small hole in the bottom and it will b fix
Originally Posted by 05rex8
+1 did this and no issues
.....so far.

just get the gasket from finishline. the hole might seem to help but it does not fix the problem which is the gasket.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
RevMeHarder
New Member Forum
7
Jul 12, 2025 07:22 PM
Carbon8
RX-8's For Sale/Wanted
42
Feb 27, 2020 08:39 AM
RXFEVER
RX-8 Parts For Sale/Wanted
38
Aug 29, 2018 10:14 AM
Azki23
New Member Forum
12
Jun 27, 2018 03:48 PM
RXFEVER
West For Sale/Wanted
17
Sep 11, 2016 02:51 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 05:43 AM.