Cleanest bay around here. Any big obstacles with the wire tuck?

 

Definitely one of the cleanest and the best color too

Tuck isn't hard just time consuming and try doing it without removing the front fenders for bonus points....smh

.

 

update...




.

 

 

Very nice.

 

I want that UIM in the worst kinda way...



Travis

 

Im In the middle of a rebuild.

 

 

tayler, that looks CLEAN!
nicely done.

 

Thanks! I've been better equipped financially to get caught up on some maintenance that I've put off for years. Nice to finally have everything sorted out again.

 

I'm finally ready to add to this thread!



I'm still missing a duct directly to the intake vent, but as it is now the intake is actually taking in ambient temp air.

 

is that a custom strut tower bar?

 

Corksport but it has been discontinued

 

Dropping it out the bottom this time.

Travis

 

New engine in and running early this morning, just need to finish up a few detail items and run the break in.

 

Clean man, Just ditch that air pump bracket. Cut it down and paint it and mount the baro sensor on the ECU box.

 

I probably will, I was considering the filter relocation kit but haven't really put much thought to it yet. I am painting the strut brace brackets tonight and install it along with bleeding the clutch.

 

Just realized I've never posted in here! So many super-clean engine bays!


.
.
.
Recently extended the supercharger's coolant loop tubing (the long blue coolant-return tube used to curve directly downward from the top/back of the upper intake and run underneath the intake - right between the super-hot alternator and compressor, right on top of the engine block - not good for cooling at all!).

 

look super clean

 

Hey when uploading an acceleration video of that beast on YouTube been following your built. Love it

 

Nice engine bay
what intake boot is that ? 👍

 

Where did you get your M oil cap? Jim

 

The intake is from Brainstorm tuning.You can google it.It is silicone and comes in red,black or blue.Im very happy with it and it fits the Racing Beat intake.

 

I have same setup for my airbox with few changes, shaved all liner fines, removes lower air resonator and use K&N cone filter.
It has enough place for oil catch can also its nice to see flexion of plexiglass under WOT.

 

I'll add to the gallery. My bay is definitely function over form.
.