Rear Brake Calliper Piston Tool Details...will it fit and what size
1 Attachment(s)
Got one of these Calliper Piston winder in tools after an issue with my sisters KIA Cerato Rear Brakes, it has similar Rear Calliper Piston/Park or Emergency Brake set up in the RX-8.....
Does anyone know if this tool (see pic) will fit the RX-8, and does anyone know the actual distance between the TWO Pins (on the RX-8 Piston) that the tool locks onto the Calliper Piston to wind it back in. https://www.rx8club.com/attachment.p...1&d=1314610919 Thanks |
1 Attachment(s)
I've used a different tool with success - see attached. The pins on mine are about 7mm in diameter are are spaced 27mm apart edge to edge, or something like 34mm center of pin to centre of pin - hope that helps!
|
Hi..
The multi one I have has posts or pins of 5mm and at a distance apart (inside between each of 2 pins or posts) of 23mm..sound about correct? |
Originally Posted by ASH8
(Post 4065711)
Hi..
The multi one I have has posts or pins of 5mm and at a distance apart (inside between each of 2 pins or posts) of 23mm..sound about correct? Otherwise, this is the exact kit I have and it'll fit anything: http://www.ebay.com.au/itm/DISC-BRAK...item53dd61139e |
Originally Posted by ASH8
(Post 4065691)
Got one of these Calliper Piston winder in tools after an issue with my sisters KIA Cerato Rear Brakes, it has similar Rear Calliper Piston/Park or Emergency Brake set up in the RX-8.....
Does anyone know if this tool (see pic) will fit the RX-8, and does anyone know the actual distance between the TWO Pins (on the RX-8 Piston) that the tool locks onto the Calliper Piston to wind it back in. https://www.rx8club.com/attachment.p...1&d=1314610919 Thanks |
There is a great DIY on this subject. I know the author states the exact size spanner to use. I want to say is was _ _-14 (the blanks being letters I dont recall at the moment) My cube isn't labeled, though, so I have no idea what size it is.
|
That one worked fine for me too Ash. Had no issues spinning the piston in one bit. Boots were a little dry and had to lube them up to get them back in the groves. But that was it.
|
Thanks guys!!!..
The one I have looks the same as the pic above, but, is a chrome color...so I guess it is the same unit? My cube takes a 3/8th square wrench fitting, the cube itself is one inch square.. Sound about correct? |
I found that my rear brake caliper poiston get jam if don't drive for 1week. So what is the problem can any one tell me pls.
|
All times are GMT -5. The time now is 02:33 PM. |
© 2024 MH Sub I, LLC dba Internet Brands