Greddy Pulleys Need english instructions
Hey i just bought the greddy pulley kit for my rx8 but the instructions are all in chinese and japanise . i was looking for anyone that may have them in english and could send me a copy. Thanks
|
do you actually need instructions??
|
Only reason I could think of is for the proper torque specs????????
OP, if the kit includes an alternator pulley, make sure you go get an impact wrench to aid in getting it off! And, I don't know if these are under driven(and came with belts of not), so they could us different belts?????? |
i have the Greddy pulleys. they do not come with a belt. use an impact wrench like already mentioned for the alternator bolt(21mm i believe). remove the screws on the water pump pulley10 or 12mm). you will need to loosen the alternator by turning the nut on the top of the bracket. you will need to loosen the one on front first. then the belt will come loose. remove your pulleys. install the new ones. the water pump one uses new screws. the alternator reuses the stock one. put the belt back on. tighten everything back up.
|
BTW, they are not under-driven, just lightened.
|
1 Attachment(s)
|
Originally Posted by nuke0907
(Post 3586308)
BTW, they are not under-driven, just lightened.
You got the torque specs for him? Wondering if the would be the same as stock in that regard? |
they are the same. i do not have the specs though. i just kinda tightened them til it felt right. lol.
|
Yeah........most important thing is to check them after a few drive cycles to insure they are still tight.
|
Yeah.............I suppose.
You're always bringing up those little things! :o: After the install................ Turn the car to on but do not start Pump the brake pedal 20 times in a 8 second period If you did it right the oil pressure gauge will sweep, if it doesn't....then start over again. |
Thanks For the replys!
|
if the pulleys are just lightened do you really need to reset the e-shaft?
|
Originally Posted by Charles R. Hill
(Post 3586348)
Shall we remind the OP about resetting the e-shaft sensor, too?
Isn't this done only if you replace the e-shaft pulley? As the e-shaft sensor is located by the e-shaft pulley and it reads the way it spins. I could be wrong... but if you only replace the alternator pulley and the water pump pulley, you didn't mess with the eccentric shaft sensor, so in my opinion it doesn't need to be reset. Unless you replace the main e-shaft pulley... https://www.rx8club.com/series-i-trouble-shooting-95/real-way-clear-memory-169443/ |
Originally Posted by Charles R. Hill
(Post 3586618)
ANY time the e-shaft pulley is removed the sensor profile needs to be reset. So says the FSM.
From Nuke's photos it looks like the GReddy Pulley Kit includes an e-shaft pulley. |
I was wondering as well with the greddy pulley kit can you use the stock belts or do u need a difference size belt. If so whats the number on the belt
|
^ And the odd filter re-location kit.....that is also in Japanese....FML, but it shouldn't be too hard.
|
Originally Posted by AndymanRx8
(Post 3586695)
I was wondering as well with the greddy pulley kit can you use the stock belts or do u need a difference size belt. If so whats the number on the belt
|
service manual in my signature.
|
Does anyone Know About the belt tension. Tourque specs ????
|
There's a service manual for those things...
|
All times are GMT -5. The time now is 09:20 AM. |
© 2024 MH Sub I, LLC dba Internet Brands