Trunk Weatherstripping
 

Hey guys. Just replaced the weatherstripping in my trunk where the lid closes. I was just reading and a lot of articles say to use adhesive, but my old weatherstripping came out very easily and there is a thin rail of metal that the weatherstripping goes over. It actually goes up into the middle of the weatherstripping. Didn't look like there was any adhesive on the old one. Do I need to use adhesive???

Also could some people send me a few photos of their trunk weatherstripping. I just want to make sure I put it in right and I could use some photos to compare. There were some red marks on the new weatherstripping and I want to make sure I have them lined up where they are suppposed to be. Thanks.

Does it just pull out and clip in without needing to remove any body trim panels, etc?

Correct. It is pressed on the body. Just open the trunk and pull on the gasket to remove. As the post right above yours states, it is fitted onto a thin metal strip on the trunk body.

i appreciate the clarification; I was afraid i'd have to tear into the trim panels!!