trouble codes 3!!!
First off yesterday i was driving.. and in first gear only around 5.5-6.5 K rpms the car would jerk.. never happened before..
power seemed ok... check engine like comes on (solid light) and keep jerking but only feel it in 1st gear.. Today i wake up check all my fluids.. oil coolant, Etc.. soo i start driving and yesterday i re set the ecu by unplugging the batt and it ran fine.. this morning (continuing) it jerked a lot in that range and my power went DOWN! i didnt have any power.. and check engine light came on again.. codees are p2004 p0039 p2070 any info would be helpful |
Ahh found out what some of them are...
SSV stuck open??? and the other one is APV stuck open??? how in the heck would that happen? |
carbon build up.. drive it hard..
|
could it be carbon build up?????
i mean ai always use supreme Gas... I always use fuel injector cleaner (lucas) Sea foam. Oil changes at 3K miles.. its well maintained.. I dont granny shift i shift usually around 5K rpm.. Sometimes at 6K rpms I rev it up everyday.. |
Could be carbon, but if both codes happened at the same time (was the check engine light off before this problem happened?) it's most likely a wiring problem, or a PCM malfunction IMO. The former is more likely, and will be hard to diagnose... the latter will be expensive. If you don't know your way around a volt meter and a wiring diagram, take it to a shop that knows a bit about RX8s or a dealership that you trust and have them look at it.
Also, are you certain about code P0039? That code isn't even mentioned in the service manual :uhh: |
idk thats what came up lol. hahah
Well the first code that came up was p2070 and i reset the ECu and it camer back on... re set again And this morning the ligth came back on.. and instead of p2070 it threw the code p2004 |
All times are GMT -5. The time now is 11:31 AM. |
© 2024 MH Sub I, LLC dba Internet Brands