Originally Posted by Grace_Excel (Post 3999424)

Yes, you only need one working key to program the FOB and make sure you buy the right Model.

Old:
Visteon Model: 41848
FCC ID: KPU41805
IC: 4238A-12076

What you need to buy:
Visteon Model: 41525
FCC ID: KPU41788
IC: 4238A-41525

Originally Posted by phey_05 (Post 3671645)

Just got my switchblade today...
totally works on my 2004 MT...

unit i bough on ebay:

FCC ID: KPU41788
IC : 4238A-41525
VISTEON 41525

i just followed this instructions: (few modification to be more NOOB friendly like me)

Remote Programming
• Ensure that all doors, trunk, and hood are closed,
• open the driver’s door
Carry out the operation below within 24 seconds:
• Insert key
• Turn ignition to the run position and off, 3 times (on-off, on-off, on-off)
• Leave key in ignition (off position, not lock or on)
• Push door switch, 3 times (The door switch is the little rubber one on the jamb of the rear door next to your elbow when sitting in the driver’s seat, which controls the interior lights.)
• Car will lock, then unlock automatically after pressing the door switch 3 times
• While the car is in unlock mode, Push 'Lock' on your newly acquired remote 2 times, (some suggest unlock, so try both)
• You will notice after pressing the Lock button on your remote, Car will lock, then unlock automatically again.
• Take out you key on the ignition and test your remote.

If it doesn't work, wait for a minute or so and repeat the procedure


NOTE: I DONT HAVE any existing remote. so no need to have an existing remote to do this procedure