RX8Club.com

RX8Club.com (https://www.rx8club.com/)
-   Series I Trouble Shooting (https://www.rx8club.com/series-i-trouble-shooting-95/)
-   -   engine light? (https://www.rx8club.com/series-i-trouble-shooting-95/engine-light-191694/)

jenifer 02-22-2010 12:56 PM

engine light?
 
As long as I have owned my 06 AT the engine and the tire pressure light has stayed on due to cold air intake and after market rims I posted about haveing what felt like power loss well it still does the jolting and staling when I get into the gas pedal I haft to down shift to get a response well anyway the engine light is staying off now I don't know what this could mean? What any off my problems mean at that!

Vlaze 02-22-2010 12:59 PM

Your tire light is on because you likely don't have the TPMS installed on your new rims or they don't accept the TPMS at all so it can't sense the sensors anymore.

Try cleaning your MAF sensor, and what kind of aftermarket cold air intake is it? I would suggest trying to reset your ECU via disconnecting the negative cable off the battery to reset it so it can map to your intake.

jenifer 02-22-2010 01:31 PM

Greddy! Along with my greddy exaust but that would make the light stay on to I would think

The Reverend 02-22-2010 01:34 PM

An 8 owner down here has the Greddy CAI as well and was experiencing similar symptoms. He put an intake screen on his Greddy intake and it made it better, but I think he still stalls out sometimes.

Vlaze 02-22-2010 01:36 PM

A few things come to mind; MAF sensor needs to be cleaned, ECU needs to be reset, possible O2 sensor failure. If you have the original cat on you might have a bad cat as well depending on how many miles are on the car.

If you're getting an engine light, stop at a gas station that has a garage and ask them to read the CEL code for free and come back to post what it is. This will guide you better towards the main culprit.

StealthTL 02-22-2010 02:16 PM

Please don't do this......

The Tech Forum has a list of over 140 specific engine codes for this car - if you can't be bothered buying a $40 code reader, or stopping somewhere that will read it for free, please don't come here and ask us to waste time at guessing...."my engine light is on, what do you think it could be?"

Please.

S

jenifer 02-22-2010 10:08 PM

First off thanks for mis reading my post!! I said as u will read up on the first post I said my tire and engine light stay on due to my after market mods genius! I don't need u to come into my thread and post if you can't read and understand what I have said..

jenifer 02-22-2010 10:12 PM

I went ang got all that checked out but mazsa says all that is good! Idk what the deal. Someone said it could be the fuel pump over heating! Ill haft to try the screen for my greddy tho! But its just crazy how eveythings backwards and I know its acting up but mazda can find anything wrong..

jenifer 02-22-2010 10:23 PM

Spelled some stuff wrong sry

xtreme velocity 02-23-2010 09:14 PM

I am her husband. We were just trying to figure out why her check engine light would go off out of nowhere. I am thinking it was because while hooking up her system the ecu reset its self when batt got unhooked. Then the car ran its self checking it had realized once again that there is a problem with car (aftermarket parts) the engine light has came back on now. Car runs great. Just as it always has. So I believe the problem in question has been resolved. We do thank you guys for all the info though. I might go to parts store and pull codes to see anyway. Just to know for sure it is exhaust. Stay posted for the codes. It might be a few days though. Thanks again


All times are GMT -5. The time now is 10:12 PM.


© 2024 MH Sub I, LLC dba Internet Brands