i just got a diff shift **** for my 8 and now the shift boot doesnt meet up to the ****...you can see the shaft of the shifter and it looks bad imo.....how can i make it meet up with ****....i already tried velcro but it didnt work so well....thanks

 

nobody????

 

I have an AT. No boot. Sorry.

 

Fail

 

How long?

Mine was way low until after about a week with my new ****; then the boot started rising to meet it...

 

had it on almost a week now...

 

got a picture?

there is a piece of fabric around the shift arm under the shift boot. you can probably feel it. i would say replace that with something longer. it will help keep the boot up.

 

too dark right now to get a pic...but the boot is about an inch below ****

 

If it's the stock boot my guess is the plastic clip at the top has snapped into several pieces and so is no longer able to ride the shifter and form a seal with the shift **** like it was previously designed to do.

 

plastic clip???? didnt know there was one...

 

Just put more foam in in it.

 

that's what i said. put something under it to support it up. stock already had a piece of fabric under there.

 

stuff a couple of socks( clean ones by the way)in the inside of the boot to prop it up.