Renesis Bridgeport wont brap ? Try the Brettspeed Braphole !
#3
interesting
#12
I actually don't run it like this myself , it's just something that happened when i was playing with ideas . Vacuum is around -9psi from memory .
Would you believe I've had several people come to me wanting their bridgeport to brap? They don't even care about fuel mileage or that fact they lost power . They just want it the BRAAAAAAAPP!!!!!!!
Would you believe I've had several people come to me wanting their bridgeport to brap? They don't even care about fuel mileage or that fact they lost power . They just want it the BRAAAAAAAPP!!!!!!!
#14
Gold Wheels FTW
iTrader: (1)
What I hated most about my bridge was the surge up the secondaries. It made the SSV rattle like it was dead, and made it stick from all the oil and fuel deposited on it from the surge. Had to tear it down and clean the assemble once or twice a year. I never recommend a bridge to anyone.
I can't wait to pull that motor and stuff the 20b in.
I can't wait to pull that motor and stuff the 20b in.
#15
What I hated most about my bridge was the surge up the secondaries. It made the SSV rattle like it was dead, and made it stick from all the oil and fuel deposited on it from the surge. Had to tear it down and clean the assemble once or twice a year. I never recommend a bridge to anyone.
I can't wait to pull that motor and stuff the 20b in.
I can't wait to pull that motor and stuff the 20b in.
The following users liked this post:
ogwazza (04-06-2022)
The following users liked this post:
ogwazza (04-06-2022)
#20
Registered
I did this mod for my half bridge and it did not make any difference. I was using it for the rattle that goes along with the bridge, but it still rattles something fierce. Honestly, I think it brapped more without the mod, but that was not the reason for trying this method at all. I must say that I got excited when I saw this, but after using a spare SSV for the attempt, I couldnt help but notice that the holes drilled only allowed the air to push back into the corresponding port. So I dont see how this would make any difference, but I already had the holes drilled, so I tried it anyway. Back to the drawing board I guess
Thread
Thread Starter
Forum
Replies
Last Post
9krpmrx8
RX-8 Discussion
8
10-27-2015 03:59 PM
hfalex
Series I Major Horsepower Upgrades
78
04-06-2006 11:51 AM