Need help/tip with putting rear link back on
While attempting to install Autoexe rear memberbrace, I unscrewed the bolt holding the rear link.
This is the rear link that's out. (sprayed yellow) http://www.swankmonkey.com/mig/albums/tein/IMGP1561.JPG I can't seem to align it properly to screw it back on. Will this require undoing the whole rear suspension? Any advice will be greatly appreciated. |
Unbolt the shock to give it some slack, under the brake rotors should be a pivot point for another arm. Carefully put a jack underneath it and jack it up, this will help you realign the rear link that's out. After that, just put back on the shock and you're done. :)
|
Originally Posted by Renesis SE3P
(Post 2969348)
Unbolt the shock to give it some slack, under the brake rotors should be a pivot point for another arm. Carefully put a jack underneath it and jack it up, this will help you realign the rear link that's out. After that, just put back on the shock and you're done. :)
I meant to post this. https://www.rx8club.com/attachment.p...7&d=1115734807 This is the one that goes from under the brake. Should I still go with undoing the shock bottom to realign it? |
1 Attachment(s)
See attachment
|
All times are GMT -5. The time now is 11:53 PM. |
© 2024 MH Sub I, LLC dba Internet Brands