RX8Club.com

RX8Club.com (https://www.rx8club.com/)
-   Series I Tech Garage (https://www.rx8club.com/series-i-tech-garage-22/)
-   -   is my oil choice safe if I don't know what previous owners used? (https://www.rx8club.com/series-i-tech-garage-22/my-oil-choice-safe-if-i-dont-know-what-previous-owners-used-234983/)

Flonker 06-24-2012 07:38 PM

is my oil choice safe if I don't know what previous owners used?
 
Bought an '05 a few weeks ago. After driving it for a while I wanted to top the oil off but wasn't sure what the dealer had in it. I'm assuming they used what the manual says if they put anything in themselves, but I didn't want to take it for granted so I went where I usually go if I'm not up to doing it myself.

My concern is that I'm not sure what type of oil had been used in the vehicle all along since I'm driving a used '05 and there is that idea that 'once you go synthetic you don't go back'.

I had the shop put conventional 5w-20 in it for the time being while I start making decisions about what I'm going to use as a long term choice.

Should I be at all concerned about having this oil in there right now not knowing what previous owners may have used in the engine on a regular basis?

56k miles btw

nycgps 06-24-2012 08:15 PM

oh my god

SEARCH

well, a little tip for you, using 5w20 means you are killing your engine. Slowly but SURELY, it's PROVEN with ENGINE TEAR DOWNS.

RIWWP 06-24-2012 08:54 PM

https://www.rx8club.com/new-member-forum-197/new-potential-owners-start-here-202454/



Which oil to use

The most debated question in the community, bordering on a religious war, so I won't try to cover every point here.

It boils down to deciding for yourself.

Some go with 5w20, to stay with Mazda's recommendation in North America. Some go with 5w30 to go with Mazda's recommendation outside North America. Others go to 10w40 or even 20w50, the most common weights among RX-7s. The general arguement revolves around if 5w20 is too thin or not. Typically, you want to go with a heavier weight oil (higher numbers) the hotter the environment you live in. Many manuals outside of North America state something to this effect. So research up on it, and make your own decision.

Dino vs synthetic is another hot topic, with the main arguement revolving around if the strength of the synthetic is worth the cost, and if there is any better burning (or not better burning) than dino oils, and if any deposits are left behind that could increase engine wear. Mazda only recommends non-synthetic, but does not require it. Your decision.

One point to keep in mind is that OIL WEIGHT AND OIL TYPE HAVE NO KNOWN IMPACT ON ENGINE FAILURE METHODS. In theory, the only way that oil weight could impact an engine failure is if it is a bearing failure. Oil weight has zero impact on the internal seal lubrication. Bearing failures are incredibly rare. In theory, the only way that oil type could impact an engine failure, is if you subscribe to the belief that injected synthetic is worse to burn than injected dino. This is belief based only. No one has been able to provide evidence for burn quality one way or the other.


And yes, all weights of oils mix with all other weights of oils, roughly averaging the numbers. Half 5w20 and half 5w40 is roughly 5w30, for example. Not precisely, but close enough. Dino also mixes entirely fine with synthetic.
thread closed.


All times are GMT -5. The time now is 10:28 AM.


© 2024 MH Sub I, LLC dba Internet Brands