Help with engine codes
Thread Starter
Registered User
iTrader: (1)
Joined: Jan 2004
Posts: 1,752
Likes: 0
From: WHITE HOUSE
Help with engine codes
Ok hooked up the scanylaser from hymee and got the codes that are causing the engine light.Let me start by saying i have pullies ,high flow cat. racing beat intake,EXHAUST.
1. P2270 Rear HO2S signal stuck lean ON 2 HO2S ´ (See DTC P2270 )
2. P2096 TARGET A/F FEEDBACK SYSTEM TOO LEAN ON 2 FUEL SYSTEM
Then the hymee scanylyser says pending codes
p0302 and p2270
anyone have any ideas ??????????????????????
1. P2270 Rear HO2S signal stuck lean ON 2 HO2S ´ (See DTC P2270 )
2. P2096 TARGET A/F FEEDBACK SYSTEM TOO LEAN ON 2 FUEL SYSTEM
Then the hymee scanylyser says pending codes
p0302 and p2270
anyone have any ideas ??????????????????????
Administrator
Joined: Jul 2002
Posts: 21,958
Likes: 115
From: portland oregon
https://www.rx8club.com/series-i-tech-garage-22/rx-8-technical-info-cel-codes-pcm-pin-list-collision-guide-26291/
you are running too lean. the 302 code is misfire. it counts the misfire and when it gets over a threshold number lights the cel. reset your pcm make sure the intake is in there tight with no leaks.
you are running too lean. the 302 code is misfire. it counts the misfire and when it gets over a threshold number lights the cel. reset your pcm make sure the intake is in there tight with no leaks.
Thread
Thread Starter
Forum
Replies
Last Post
xAgyex
Series I Trouble Shooting
24
Jul 26, 2025 01:15 PM
