RX8Club.com - CEL TCS/DSC problem

RX8Club.com (https://www.rx8club.com/)

- Series I Tech Garage (https://www.rx8club.com/series-i-tech-garage-22/)

- - CEL TCS/DSC problem (https://www.rx8club.com/series-i-tech-garage-22/cel-tcs-dsc-problem-166019/)

CEL TCS/DSC problem

So I went out just now to start up my car and it started fine, but the CEL and TCS/DSC light came on and stayed on. Car is idling fairly high, and there's no response what-so-ever from the gas pedal. Anyone? I should mention that it's about -18 C outside right now.

Thanks.

Well, could be anything. If it's under basic warranty then have it towed to a dealer.

However,

Very cold weather and low battery voltage can produce all sorts of transient problems. The electric power steering consumes a ton of amps.

First, Let the car idle for few minutes so it doesn't flood when you shut it off.

Do a DSC reset. With ignition on, turn the steering wheel all the way to the left, then to the right, and re-center. Turn the engine off. This should reset the DSC light.

Take the car for a long (+30 mins) drive to replenish the battery.

The Check Engine light will probably turn off after a couple of drive cycles.

Good luck.

Quote:

Originally Posted by Silver06 (Post 2851215)

Thanks for the reply. Went out a little later and started it and DSC light was off, got response from the gas pedal and CEL still on, which I can deal with. Dunno, something was just frozen, I guess.

Your initial problem sounds like what I am dealing with right now. ( https://www.rx8club.com/series-i-trouble-shooting-95/cel-butterfly-valves-driving-pedal-position-sensor-165147/ )

If it happens again see if you can get the code. So far I haven't been able to fix my problem yet. Hopefully your issue isn't a hard fault.

Good luck to you!

mkztg