RX8Club.com

RX8Club.com (https://www.rx8club.com/)
-   Series I Tech Garage (https://www.rx8club.com/series-i-tech-garage-22/)
-   -   a/c question (reset to make colder?) (https://www.rx8club.com/series-i-tech-garage-22/c-question-reset-make-colder-246172/)

yamajj 05-25-2013 11:47 AM

a/c question (reset to make colder?)
 
when i joined here several years ago, there was a trick to make the a/c blow colder and harder automatically, by pressing a couple of buttons. does anyone know how to do this or remember? i lost the piece of paper it was on and i just changed my battery.

thnx. yamajj

EDZRIDE 05-25-2013 12:13 PM

Do a search on a/c reprograming

wcs 05-25-2013 12:13 PM

This?

AC NOT COOL (AFTER 9/11/03 PRODUCTION)
Applicable Models
Model Starting S/N Ending S/N
2004 RX8 40118171 ********

Some customers may complain of lack of AC cooling from the vents. This may be caused by the intake air selector (recirculate / fresh) in the "FRESH" mode. Cooling the interior of the vehicle may take longer if the air intake selector is in the "FRESH" mode. Maximum cooling is achieved when the intake air selector mode is in the "RECIRC" position. The AC amplifier can be programmed to automatically default to "RECIRC" mode when the following conditions are met:
1. Ambient air temperature is 68 deg. F or higher.
2. HVAC control mode is in "FACE" mode.
3. HVAC temperature is in maximum cool setting. Customers with this concern should have their vehicle repaired using the repair procedure. NOTE: Vehicles produced before 9/11/2003 are not programmable and should have the AC amp replaced per Service Bulletin # 07-002/04

1. Verify concern.
2. Verify ignition switch is in OFF position.
3. Press and hold the front defrost and air intake selector buttons simultaneously.
4. Turn the ignition key to the "ACC" position for 3 seconds. (Continue to hold the buttons down from step #3.)
5. Turn the ignition key to the "ON" position for 3 seconds. (Continue to hold the buttons down from step #4.)
6. Successful programming will be confirmed by the rear defrost indicator light flashing 3 times. NOTE: If vehicle's battery dies or cables are removed, the programming will not be retained and must be performed again.

yamajj 05-25-2013 04:12 PM

thnx much wcs. bet i put this in my safe this time. lol

yamajj


All times are GMT -5. The time now is 12:51 AM.


© 2024 MH Sub I, LLC dba Internet Brands